Matsushita CF-08TX1A1M manual Setting the SW LED PCB, Assembly of the LCD Block

■Assembly of the LCD Block

0~1mm

Attach the Conductive Cloth to the Mg side.

(Remove the Release Paper only of the attaching part.)

Safety Working

When the Cable is close to the edge

(more than 4 mm than the standard position), ensure that the Cable is not wound in other parts.

Pet Tape 1 LCD Block Pet Tape 1 Pet Tape 1

edge standard: +0.5 mm
-
0~3mm	0~3mm		0~3mm
5~6mm			5~6mm
Put inside	5~6mm	5~6mm
the rib.

Match to the edge of the

Connector.

Shield Tape	Busterade	LCD Side
Safety Working
		Cushion T8
		Attach to the	Caution High
0~1mm		undersurface.
			Voltage Label

1~3mm
		1~3mm
0~1mm	Put inside
	the rib.	Note

	Frame edge	Caution to High Voltage
	standard
	+0.5mm
	-
	Board edge
LCD Signal Cable	standard
	+0.5mm
	-	LCD Side	LCD Side Cushion Thin within the rib
	edge standard: +1mm
	-	Cushion T5	After the liquid crystal block is set, attach LCD
			side cushion TS and LCD side cushion thin with
		Shield Tape	their gluing sides facing downward.

Shield Tape

Frame edge standard

+0.5mm

-

Board edge standard

+0.5mm

-

LCD Side Cushion T5

9.2.3.Setting the SW LED PCB

1.Connect the Cable to the connector (CN501) of the SW LED PCB.

2.Attach the tape.

3.Fix the SW LED PCB and SW Board Stopper Plate using three Screws <N2>. No1 to No3

4.Put the Cable into the Clamper.

Note:

Tighten the Screws in the numbered order (No1 to No3).

Screws <N2>:DRSB2+5FKL

Connector(CN500) No.1 SW Board Stopper Plate No.2 <N2>

<N2>

SW LED P.C.B.

No.3

<N2>

Connector(CN501)

9-11