Matsushita CF-30 service manual Troubleshooting, Flow Chart

4.2. Troubleshooting

Please take note of the following two points with regard to troubleshooting:

1.Know-how of diagnosis upon occurrence of heavy troubles, e.g. Set cannot be turned ON , Set fails to start , No display on screen , etc.

2.Explanation of each trouble, mainly symptom of trouble in operation.

Flow Chart

START

Set cannot be supplied with current. Power lamp fails to light up.

Pay attention to the following points when in pursuit of the cause of a troubleshooting.

1.Peripheral apparatus connected with the set should all be removed before operation check.

2.Make sure that cables, boards, etc. are not coming off, and recheck the contact condition.

AC	NG
Adaptor/Battery		Replace AC Adaptor/Battery
Output voltage

OK

Dark display on screen. Screen fails to display.

Power lamp	NO
check	YES
Inverter board	NG
	OK
LCD back	NO
light lighting

Check contact condition of power input terminal. Replace if defective.

Check Power SW. Replace if defective.

Replace inverter board.

Check inverter cable continuity. Replace if defective

Replace LCD back light.

Failure in starting

YES		NG
LCD unit
check	OK
BIOS operation		NO
check	YES
Result of		NG
POST	OK

Replace LCD unit.

Replace main board (Check fuse at power source).

Refer to POST
	Replace main board.
error code table.

Not displayed properly on screen.

	NG
Set-up utility			Heavy trouble e.g.,
		Replace main board.
starting			Set cannot be turned
OK			ON , Set fails to start ,
			No display on
Return set-up utility setpoint to the state of delivery from factory .			screen , etc.
	NO	Check HDD cable connection and continuity.
HDD access		Replace if defective.
		Replace HDD & Reinstall.
YES		Replace main board.
Main board	NG
		Replace main board
check

Some or all keys cannot be input.

OK

Make sure of contact of K/B connector in use. Replace keyboard or main board.

Each kind of trouble in operation.

CD CALL not practicable.

Starts but operates unstably.

TroubleNO symptoms on some

of CD

YES

Replace main board.

Reinstall HDD.

Replace main board.

STARTEND

Check if there are any flaws on CD media. Since flaws may appear on specific media, CD media can be defective.

4-2