Marshall electronic V-R261-DLW IMD Config Submenu, Overview, Imd Id #, IMD Group #, IMD Protocol

Page 23

IMD Config Submenu

Overview

The V-R261-DLW features an In-Monitor Display (IMD) with the ability to display on-screen text and tally in three colors. IMD text, color, and alignment can be assigned to each screen locally using menu options (see below). Alternately, IMD text and tally can be remotely controlled via the RS-422/485 serial interface using several industry- standard protocols, including TSL v4.0 and Image Video. Multiple V-R261-DLW monitors can be looped together and each addressed individually via the protocol. All menu features of the V-R261-DLW can also be controlled via the Marshall Network Controller box using MEI protocol. (Contact Marshall Electronics for additional information).

Use the IMD Configuration submenu to configure various IMD parameters as described below.

IMD Configuration Submenu

IMD ID #

The IMD ID # identifies each screen to the controlling device. When using the TSL protocol, the ID # of each screen should be manually set in conjunction with the controlling device. When using the Image Video protocol, the ID # may be set automatically by the controlling device, after each IMD is initially identified by IMD Name (see “IMD Name[S/N]” below). Available ID #s are 000-254.

IMD Group #

Each screen can be assigned an IMD Group # when using the Marshall protocol. Available Group #s are 01-254.

IMD Protocol

Use the IMD Protocol menu option to choose the protocol with which the V-R261-DLW receives remote commands. Currently, four protocols are available. Contact Marshall Electronics for the latest protocol compatibility.

Image Video

Use the Image Video protocol setting when controlling the IMD from an Image Video tally controller (e.g. TSI- 1000) or other controlling device which utilizes the Image Video protocol. The IMD #, IMD Name(S/N), and Baud Rate parameters must be set for each screen in conjunction with the controlling device.

23

Image 23
Contents Model No. V-R261-DLW Operating InstructionsThis page intentionally left blank Contents Multi mode, Vectorscope and Waveform Monitor mode FeaturesUnpacking Installation and Initial SetupInstallation Connections, Power-On and Initial SetupPower Button Front Panel FeaturesRS-422/485 Serial Interface Rear Panel FeaturesFollowing SDI standards are supported by the V-R261-DLW Compatible Input FormatsDLW Monitor Layouts Waveform Monitor Mode Full Screen Video Mode On-Screen Menu On-Screen Menu Marker Setup SubmenuMarkers Center Marker Marker BackgroundBlue-Only Mode Video Config SubmenuMonochrome Mode Aspect Ratio Settings Pixel-to-Pixel ModeCurtain Color Analog Phase DVI-Analog or VGA input onlyDVI-A CSC Mode DVI-Analog input only DVI-D CSC Mode DVI-D input onlyHdmi CSC Auto Hdmi input only, via the DVI-I interface Color Config SubmenuSystem Config Submenu User-Definable Function Buttons Saving and Loading User PresetsStatus Display OSD Config SubmenuIMD State LED Tally OSD TallyCC Monitor Closed Captioning OSD TimeoutAnc. Timecode Audio MonitorIMD Group # IMD Config SubmenuOverview IMD ID #TSL Tally SourceIMD Name S/N IMD Fixed Config SubmenuIMD Tally Mode IMD Baud RateIMD Fixed String ServiceClosed Captioning Submenu IMD Fixed AlignColor Waveform ModeWave/Vector Submenu Waveform Scale Ancillary Submenu DID/SDID Software Version Display Service SubmenuPanel RS-422/485 Serial Interface RJ12 SpecificationsDimensions Burn-In Warning MaintenanceWarranty Screen CleaningThis page intentionally left blank Marshall Electronics, Inc