Me Inc NumaLink-3.0 manual Configuration File

Page 29

-efile

-ffile

-q

-tseconds

-v

NumaLink-3.0™ Users Guide and Service Manual

data

3 – Write; writes intermediate format to output files

This argument is mutually exclusive with –b.

Error log file specification – specifies a file for writing an error log and supplementary error information. The error log receives any error messages that are generated during translation. The process must have write, file create and directory create access to this directory.

If “0” is specified for the path, error messages are not logged. In interactive mode (-b) error messages are always displayed on the standard error device, regardless of this argument.

Configuration file specification. The configuration file indicates the translation types to be performed, and is specified in section 7.2.

Quiet output. This causes only error messages to be displayed. The default is normal output – a small number of informational messages and any error messages.

This argument is mutually exclusive with –v.

Wait time – the number of seconds to wait before rechecking the input file path(s) for work. The default is 30 seconds.

This argument is ignored unless –bis specified.

Verbose output. This causes a large number of informational messages to be displayed as well as any error messages. The default is normal output – a small number of informational messages and any error messages.

This argument is mutually exclusive with –q.

7.2 Configuration File

A configuration file is used to designate the types of translation to be done. Each type of translation type must specify at minimum an OEM format and path for input as well as output, and a work path. The translation type may also include remote DICOM AE information and customization settings.

The configuration file is a text file. Each line of text specifies one directive; the type of each directive is denoted by a leading keyword. The following general rules apply to the configuration file:

;

(semicolon)

Comment – everything to the right on the same line is ignored.

!

(exclamation)

 

 

 

The semicolon delimiter may be used freely to mark comments; the

 

 

exclamation delimiter is reserved for use by Numa, Inc.

Page 28 of 33

Image 29
Contents April NumaLink-3.0 VersionFor more information contact Numa Table of Contents Introduction Cabling Installation and Getting StartedHardware Startup Shutdown and RebootLicense Installation DirectoriesSoftware Removing NumaLink-3.0 License Error MessageNumaLink Product OverviewDicom Typical TranslationPage General ConfigurationNumaLInk-3.0 Dicom Application Entity Information Translations Translations Tab Translations Settings Dicom CustomizationDicom dialog Dicom Settings NumaLink-3.0 Dicom Conformance Statement StatusPage Technical Support Logging and Error ReportingRemote Diagnostics PcAnywhere Icon TroubleshootingFrequently Asked Questions Page Page NumaLink-3.0 Input Configuration Pegasys Read OEM Setup InformationNumaLink-3.0 Output Configuration Pegasys Write Adac PegasysNumaLink-3.0 Input Configuration Odyssey Read NumaLink-3.0 Input Configuration StarCam ReadGE StarCam Marconi OdysseySiemens Icon NumaLink-3.0 Input Configuration Icon ReadCommand Line Command Line Interface and Configuration FileConfiguration File Translate Directive Instead Outremoteae Directive Control* Directives