Me Inc NumaLink-3.0 manual Installation and Getting Started, Hardware, Cabling

Page 5

NumaLink-3.0™ Users Guide and Service Manual

2. Installation and Getting Started

2.1 Hardware

Your NumaLink-3.0 system hardware should be installed by an authorized service engineer. Please contact Numa for more information.

Typical hardware for a NumaLink-3.0 system is shown in Figure 1.

Figure 1 – NumaLink-3.0 Hardware Configuration

AC

 

 

 

Monitor

To analog telephone

 

Modem Line

Video

outlet

 

 

 

Network

 

ACPower strip

 

Hub

 

Mouse

 

 

To Destination

 

 

System

 

To Source System

AC

 

 

 

Keyboard

 

Keyboard

Mouse

 

 

 

 

 

NL_UserMan_004

2.1.1 Cabling

Refer to Figure 1:

1.Make sure that the AC power cable is plugged into the power outlet of the computer. This is a three- pronged slot, often located in the rear corner of the system.

Page 4 of 33

Image 5
Contents April NumaLink-3.0 VersionFor more information contact Numa Table of Contents Introduction Cabling Installation and Getting StartedHardware Startup Shutdown and RebootLicense Installation DirectoriesSoftware Removing NumaLink-3.0 License Error MessageNumaLink Product OverviewDicom Typical TranslationPage General ConfigurationNumaLInk-3.0 Dicom Application Entity Information Translations Translations Tab Translations Settings Dicom CustomizationDicom dialog Dicom Settings NumaLink-3.0 Dicom Conformance Statement StatusPage Technical Support Logging and Error ReportingRemote Diagnostics PcAnywhere Icon TroubleshootingFrequently Asked Questions Page Page NumaLink-3.0 Input Configuration Pegasys Read OEM Setup InformationNumaLink-3.0 Output Configuration Pegasys Write Adac PegasysNumaLink-3.0 Input Configuration Odyssey Read NumaLink-3.0 Input Configuration StarCam ReadGE StarCam Marconi OdysseySiemens Icon NumaLink-3.0 Input Configuration Icon ReadCommand Line Command Line Interface and Configuration FileConfiguration File Translate Directive Instead Outremoteae Directive Control* Directives