2.The monitor cable should be plugged into the video card on the NumaLink computer. This is usually
3.The keyboard and mouse cables are
4.For modem line cabling setup, please refer to section 5.2.
5.Network cables should be plugged into the appropriate network ports. If your system has two separate Ethernet cards, make sure that the cables go to the correct ports. See Figure 7 for a sample interconnectivity diagram. You may need to contact the Numa, Inc. Technical Support Staff for assistance.
NOTE Do not plug two network cables into the same Ethernet card. This includes both 10base2 (coaxial) and 10/100baseT (CAT5). Doing so will damage the Ethernet card.
2.1.2 Startup
Before starting the NumaLink system, check the following:
1.All the cables on the
2.The monitor is turned on.
3.The surge suppressor power strip is turned on.
To start the
During
If your
2.1.3 Shutdown and Reboot
To shut down (power off) the
1.Click on the Start button in the lower left hand corner of the screen.
2.Select the Shut Down option from the list.
3.Click the circle next to Shut Down to select it, and then click the OK button to power off the NumaLink computer.
To reboot the
1.Click on the Start button in the lower left hand corner of the screen.
2.Select the Shut Down option from the list.
3.Click the circle next to the Restart option to select it, and then click the OK button to reboot the computer.
Page 5 of 33