Me Inc NumaLink-3.0 manual Troubleshooting, PcAnywhere Icon

Page 21

NumaLink-3.0™ Users Guide and Service Manual

TELCO

PHONE

The phone line should be

plugged in here

 

 

NL_UserMan_005

The pcAnywhere software is setup to automatically start each time the system boots up. You can verify the status of pcAnywhere by locating the clock in the lower right hand corner of the screen. Next to the clock will be a small computer icon, which indicates that pcAnywhere is setup to receive a call; see Figure 11.

Figure 11 – pcAnywhere Icon

NL_UserMan_006

If you do not see the “pcAnywhere…” icon, you may double-click the “Wait for Connection” icon located on the left side of the screen; see Figure 12.

Figure 12 – "Wait for Connection" Icon

NL_UserMan_007

5.3 Troubleshooting

Before placing a service call to Numa, please run through the following troubleshooting checklist and FAQ.

1.Are all cables plugged into the appropriate ports? (See section 2.1.1.)

2.Are the computers and monitors of the NumaLink-3.0 system, the source system and the destination system turned on? (See section 2.1.2.

Page 20 of 33

Image 21
Contents April NumaLink-3.0 VersionFor more information contact Numa Table of Contents Introduction Installation and Getting Started HardwareCabling Startup Shutdown and RebootInstallation Directories SoftwareLicense Removing NumaLink-3.0 License Error MessageNumaLink Product OverviewDicom Typical TranslationPage General ConfigurationNumaLInk-3.0 Dicom Application Entity Information Translations Translations Tab Translations Settings Dicom CustomizationDicom dialog Dicom Settings NumaLink-3.0 Dicom Conformance Statement StatusPage Logging and Error Reporting Remote DiagnosticsTechnical Support PcAnywhere Icon TroubleshootingFrequently Asked Questions Page Page NumaLink-3.0 Input Configuration Pegasys Read OEM Setup InformationNumaLink-3.0 Output Configuration Pegasys Write Adac PegasysNumaLink-3.0 Input Configuration Odyssey Read NumaLink-3.0 Input Configuration StarCam ReadGE StarCam Marconi OdysseySiemens Icon NumaLink-3.0 Input Configuration Icon ReadCommand Line Command Line Interface and Configuration FileConfiguration File Translate Directive Instead Outremoteae Directive Control* Directives