Reference Manual R FR 5010 Version1.4
Hot Swapping
Power Supplies
The Series 5000 CardModules and Power Supplies are fully hot swappable in the event of a fault or failure.
Power Supply Failure
A failure in the Primary power supply will automatically trigger the use of the redundant supply (if fitted) and will trigger the following alarm conditions / indications(requires controller option).
•Reported fault on the monitoring system
•Alarm GPO trigger on the alarm connector (see Alarm Connections section)
•Front Panel LED (normally green) will go out (See Alarm / Status indication section)
Once identified, the defective supply can be removed and replaced with power connected with no interruption to the operation of the CardModules.
CardModules
If a CardModule fails the error will be reported over the monitoring system and via the front side alarm LED. Alarm function is module dependant so please refer to the CardModule manual for failure conditions and indications. The defective CardModule can be removed and replaced with an identical replacement without removing power from the frame.
Page 27