NordicTrack 3G10WV manual AP Isolation, Point can be linked, Band, Min 54g Rate, Threshold, Beacon

Option	Description
AP Isolation	Select On or Off. By enabling this feature, wireless clients associated with the Access
	Point can be linked.
Band	The new amendment allows IEEE 802.11g units to fall back to speeds of 11 Mbps, so IEEE
	802.11b and IEEE 802.11g devices can coexist in the same network. The two standards
	apply to the 2.4 GHz frequency band. IEEE 802.11g creates data-rate parity at 2.4 GHz
	with the IEEE 802.11a standard, which has a 54 Mbps rate at 5 GHz. (IEEE 802.11a has
	other differences compared to IEEE 802.11b or g, such as offering more channels.)
Channel	Allows selection of a specific channel (1-14) or Auto mode.
Auto Channel Timer	The Auto Channel times the length it takes to scan in minutes.
(min)
54g Rate	In Auto (default) mode, your Router uses the maximum data rate and lowers the data
	rate dependent on the signal strength. The appropriate setting is dependent on signal
	strength. Other rates are discrete values between 1 to 54 Mbps.
Multicast Rate	Setting for multicast packet transmission rate. (1-54 Mbps)
Basic Rate	Sets basic transmission rate.
Fragmentation	A threshold (in bytes) determines whether packets will be fragmented and at what size.
Threshold	Packets that exceed the fragmentation threshold of an 802.11 WLAN will be split into
	smaller units suitable for the circuit size. Packets smaller than the specified fragmentation
	threshold value however are not fragmented.
	Values between 256 and 2346 can be entered but should remain at a default setting of
	2346. Setting the Fragmentation Threshold too low may result in poor performance.
RTS Threshold	Request To Send (RTS) specifies the packet size that exceeds the specified RTS threshold,
	which then triggers the RTS/CTS mechanism. Smaller packets are sent without using
	RTS/CTS. The default setting of 2347 (max length) will disables the RTS Threshold.
DTIM Interval	Delivery Traffic Indication Message (DTIM) is also known as Beacon Rate. The entry range
	is a value between 1 and 65535. A DTIM is a countdown variable that informs clients
	of the next window for listening to broadcast and multicast messages. When the AP
	has buffered broadcast or multicast messages for associated clients, it sends the next
	DTIM with a DTIM Interval value. AP Clients hear the beacons and awaken to receive the
	broadcast and multicast messages. The default is 1.
Beacon Interval	The amount of time between beacon transmissions in is milliseconds. The default is
	100 ms and the acceptable range is 1 – 65535. The beacon transmissions identify the
	presence of an access point. By default, network devices passively scan all RF channels
	listening for beacons coming from access points. Before a station enters power save
	mode, the station needs the beacon interval to know when to wake up to receive the
	beacon.
Xpress™	Broadcom’s Xpress™ Technology is compliant with draft specifications of two planned
Technology	wireless industry standards. It has been designed to improve wireless network efficiency.
	Default is disabled.

30 – 3G10WV HSPA Wi-Fi Router with Voice