Lanner electronic FW-6420 manual Radio Frequency Emissions Notice, Copyright and Disclaimers

Page 2

Copyright and Disclaimers

© Copyright 2004 - Lanner Electronics Inc.

All Rights Reserved

The contents in this publication have been thoroughly checked and considered accurate. The publisher and manufacturer of this product, Lanner Electronics, is not responsible for any violation of patents or other rights of third parties resulting from its use. Neither does Lanner Electronics assume any responsibility for any inaccuracies contained in this manual, nor make any commitment to keep the information in this document up-to-date.

Lanner reserves the right to make improvements to this document and/or this product at any given time without notice.

No part of this document may be reproduced, stored in a retrieval system, or transmitted in any form or by any means (electronic, mechanical, photocopying, recording, or otherwise, without the formal consent from Lanner.

Trademark Acknowledgments

All products and/or brand names stated in this publication are the trademarks of their rightful and associated companies.

Radio Frequency Emissions Notice

This equipment has been tested and found to comply with the digital device limits pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when operate in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area may cause harmful interference, in which case the user will be required to correct the interference at his expense.

ii

Image 2
Contents FW-6420 Series User’s ManualTrademark Acknowledgments Radio Frequency Emissions NoticeCopyright and Disclaimers Safety Instructions Getting Technical Assistance About this ManualTable of Contents Warranty Policy RMA Service P e n d i x BIntroduction FeaturesGetting Started Mechanical/ Environmental Form Factor Technical SpecificationsModel Name FW-6420B FW-6420E HumidityPacking Contents Mechanical Dimensions EM-661 System BoardEM-661 Jumpers and Connectors Board LayoutCMOS1Clear Cmos Data Jumper Settings and I/O ConnectorConnector Pin Assignments COMA1 RS-232 Serial Port #1 Connector D-Sub FAN1 3 Pin FAN ConnectorPRJK1 3 Pin Power Input Jack VGB1 External VGA Connector 2X6 Header 2.54mmPKMB1 PS/2 Keyboard & Mouse Connector 2x4 Header 2.54mm USBB1 Dual ConnectorIDEA1 IDE Interface Connector 44Pin 2.0mm Pitch Header CF1 Compact Flash Connector LPTA1 Parallel Connector 26 Pin 2.00mm Pitch Header PCIB1124-pin Mini PCI Sockets MoreRSW1 4-pin Software Reset Switch FW-6420 Mini Desktop Firewall Mechanisms Face PanelFace Panel LED Status and Behavior Gpio definitionRear View FW-6420 Rear ViewSystem Memory FW-6420 Hardware Installation GuideRemoving the Top Cover Installing Hard Disk Drive Installing Compact Flash CardInstalling the Mini-PCI Card Entering Setup Award Bios SetupRunning Award Bios Cmos Setup Utility +/-/ PU/ PDPage Standard Cmos Setup IDE Primary Slave Landing Zone Landing ZonePage Advanced Bios Features Setup Advanced Chipset Setup System Bios Cacheable Dram Dram CommandRate 2T command Video Bios CacheableIntegrated Peripherals Setup Power Management Power Management SetupPower Management Setup Screen Page PCI Plug and Play Setup Base TimerCLKReserved Memory LengthPC Health Status Load Optimal Defaults Supervisor / User Password Save & Exit Setup Exit Without SavingOutput Specifications Power AdapterGeneral Specifications Console Redirection EnabledDisabled AutoTerms and Conditions Date2004.07.08RMA Service Request Form Authorized Signatures / DatePEXNSD01-040709 Version 1.0 Printed and published in Taiwan