Qualstar 501440 Rev. G operation manual TLS-62xx and 82xx Drive Cabling Diagram

TLS-62xx

Drive 1

Drive 2

{ Filler Plate

Filler Plate	}
	~	Bridge Cables
Bridge Cable
	
Bridge Cable	€
Terminator
		Terminator

Figure 4-1 TLS-62xx and 82xx Drive Cabling Diagram

Steps 2 through 4 apply to TLS-62xx and 82xx libraries only.

2.Attach a terminator at connector 6 as shown in Figure 4-1.

3.Connect a SCSI Bridge Cable from connector 2 to the top tape drive as shown at connector 2 and 3 in Figure 4-1.

4.Connect a Bridge Cable Connector to the top and bottom tape drives as shown at connectors 4 and 5 in Figure 4-1.

Steps 5 through 10 apply to TLS-54xx/64xx/84xx and either side of 58xxx/68xxx/88xxx libraries only. Note that if both sides of a58xxx, 68xxx or 88xxx library will have FCO’s installed, the drive cabling needs to be identical.

5.Refer to the TLS-5000/6000/8000 Installation and Operation Manual (Qualstar document number 501450) for information about removing the service panel(s) on the rear of the library.

6.Connect a Bridge Cable Connector to tape drives T1 and T2 as shown at connec- tors 4 and 5 in Figure 4-2.

7.Connect a Bridge Cable Connector to tape drives T3 and T4 as shown at connec- tors 8 and 9 in Figure 4-2.

8.Attach a terminator at connectors 6 and 10 as shown in Figure 4-2.

9.Connect the shorter Changer SCSI Bridge Cable from connector 2 to the top tape drive as shown at connector 3 in Figure 4-1.

10.Connect the longer Changer SCSI Bridge Cable from connector 1 to tape drive D3 as shown at connector 7 in Figure 4-1.

11.After the SCSI cable connections are complete, see the TLS-5000/6000/8000 In- stallation and Operation Manual (Qualstar document number 501450) for infor- mation about reinstalling the service panel(s).

4-2 FCO Type A Installation 501440 Rev. G