Qualstar 501440 Rev. G operation manual Rear View of TLS

5.Using a Phillips screwdriver, secure the FCO to the rear of the library at the FCO’s two top captive screws. See Figure 4-5.

6.Using two of the screws that were removed with the service panel, attach the FCO’s two hinges to the rear of the library. See Figure 4-5.

Screw Holes (6)

Heatsink Panel Screws (4)

Captive Screws (4)

Executive PCBA

Fibre Channel

Option

FCO’s

Hinges (2)

Bottom Edge of

Service Panel Opening

Figure 4-5 Rear View of TLS

7.Loosen the two top captive screws on the FCO that were tightened in step num- ber four. Carefully guide the FCO backwards as it pivots on the hinges and comes to its open position. See Figure 4-6.

FCO in Open Position

Figure 4-6 Fibre Channel Option in the Open Position

501440 Rev. G FCO Type A Installation 4-5