Qualstar 501440 Rev. G operation manual Installing a Fibre Channel Option, Installation

TLS-84xx or one side of a 88xxx dual sided library

	{
	Bridge Cables
Drive 1
Drive 2	Terminator
Drive 3	Bridge Cables
Drive 4
	Terminator

Bridge Cables (4)

Terminators (2)

{

}

~



€



‚

ƒ

„

Figure 4-2 TLS-54xx, 58xxx, 64xx, 68xxx, 84xx and 88xxx Drive Cabling Diagram

4.3Installing a Fibre Channel Option

CAUTION

Be sure to turn the library’s power off before installing or removing a Fibre Chan- nel Option.

4.3.1Installation

The following steps outline the actions necessary to install a Fibre Channel Option onto a library.

1.Remove power from the TLS: first turn the power switch off and then remove the power cord.

2.Using a Phillips screwdriver remove the six screws securing the service panel on the rear of the library – refer to Figure 4-4.Depending of the model of library, the service panel may not have ventilation slots. Care must be taken to not re- move the four screws securing the heatsink panels. Save the service panel for possible future use.

3.For TLS-4212 and 4222 libraries only, the aluminum bracket attached to the top of the FCO must be removed before the FCO is installed. Use a Phillips screw- driver to remove the two screws and the bracket from the top of the FCO. See Figure 4-3.

501440 Rev. G FCO Type A Installation 4-3