Qualstar 501440 Rev. G operation manual Detail of Connections Executive IV Pcba Shown

SERLA and SERLB Connectors

on Executive IV PCBA

SERIAL Ribbon Cables Note: Red edge faces right.

AUXPWR Connector on Executive PCBA

AUXPWR Cable	FCO_A Connector on
	Fibre Channel Option

Q_LINK Connector on

Fibre Channel Option

PWRIN Connector on

Fibre Channel Option

Figure 6-14 Detail of Connections (Executive IV PCBA Shown)

11.Carefully lift the FCO until it touches the rear of the TLS. Using a Phillips screwdriver, secure the Fibre Channel Option to the rear of the TLS by tighten- ing all four of the captive screws. Refer to Figure 6-10for captive screw locations.

12.Install the FCO serial communication bridge cable. The serial communication bridge cable is a short telephone type cable with a six-conductor RJ11 plug on each end. Insert each ended of the serial communication bridge cable (P/N- 510149-01-6) into the RJ11 jacks on the FCO. See Figure 6-15.

Fibre Channel 0		Serial Jumper			External Cable to
					Host Ethernet Interface
SFP Interface			Connectors
					(RJ45)
				(RJ11)
	SCSI Channel 1

	SCSI Channel 0
	Serial Communication	Reset Button
	Bridge Cable
6-16	FCO Type C Installation	501440 Rev. G