Ultra electronic Turbo MS Install the parallel Interface Cable I and Ultra Secure Key

Page 14

Quick Start Guide

Ultra Electronics Card Systems

Install the parallel Interface Cable I and Ultra Secure Key

13

Switch the printer OFF. Locate the UltraSecure Interface connector on the rear panel.

Plug a good quality, screened Centronics Interface cable into this socket and secure the wire latches. Plug the other end into the Printer connector of your PC (LPT1 or LPT2)

24

Note the position for the UltraSecure Key at the rear of the Magicard Printer.

Please note that the UltraSecure logo is now a standard feature programmed into the firmware of all TURBO models. It can be switched on/off from within the OVERCOAT section of the PrintMagic driver.

If you wish to have a CUSTOM LOGO produced you must ask your dealer for a custom key order form. Your logo will then be programmed into a key of the type shown above. When the key is plugged into your Turbo it will override the internal programme and your logo will be printed instead of the standard UltraSecure logo.

Connection of the parallel cable to the rear 25-way connector on the PC.

Page 14

MAGICARD TURBO Color Printer

Image 14

Contents Magicard Turbo Color Printer Quick Start Guide forLoad the supplied Windows Driver software ConventionsPreparing a Location For the Printer Location Requirements for your printerRemoving the Printer From the Box Checking Package Contents C Optional Starter KIT Install Dye Film D RecessesQuick Start Guide Ultra Electronics Card Systems Ultra Electronics Card Systems Quick Start Guide Load Plastic Cards Cleaning the Card Cleaning Roller sticky or tacky roller Connect the Printer To a Power Supply Test Printer Operation H Install the parallel Interface Cable I and Ultra Secure Key Install Windows Driver J Procedure to be followed if your PC uses WindowsQuick Start Guide Ultra Electronics Card Systems Initialise the Setup Printer SetupPrinter Setup Colour Format / Film Card Settings Colour Adjust ECP Operation Which Mode Should I UseNon-ECP Operation Procedure to be followed if your PC uses Windows NT Install Windows NT4 DriverInstall the Windows Driver Setup Printer SetupSelect Document defaults... from the File menu Data Transfer Format Overcoat SettingsOptions Please noteBlack Format Options Film Power SettingUltra Secure Feature Degree RotationProperties Verifying Computer to Printer Communication in Windows M For Further Assistance Check the InstallationCase Difficulty Important Cleaning Procedures P Thermal Printhead CleaningCleaning the Tacky Roller Cleaning the Rubber RollersMicro Switch Cleaning the Optics Cleaning the Magnetic Head if fittedLED Error Codes Q Canadian Department of Communications Statement Limited Warranty Information EC Declaration of Conformity Ultra Electronics Ocean Systems Coles