Ultra Electronics Card Systems
Area | If area is selected the |
| coordinates define the start |
| and end of the overcoat area |
Window | If window is selected the |
| coordinates define the start |
| and end of the area that has to |
| remain blank (no overcoat) |
It is possible to define up to 10 overcoat areas or windows, they will be combined to one area or window on the card.
Prev Switch to previous overcoat area (or window)
Next Switch to next overcoat area (or window )
Enable Enable checkbox can be used to turn overcoat feature on and off. Note that the enable checkbox is valid for all overcoats (1 - 10)
Film Power Setting
The film power settings allow the user to adjust the density for the YMC, the Resin and the Overcoat print. If using earlier models, please leave the settings at default value of 50, to prevent file errors.
Black Format Options
The black format options enable the operator to use resin panel for fonts only, for every black spot on the card or not at all.
Ultra Secure Feature
With this checkbox the user can switch the Ultra Secure feature on and off, provided the Ultra Secure Key is installed on the printer.
180 Degree Rotation
This option is used to rotate the complete card layout 180 degrees to adjust for the chip position (on left or right side of the card) or the magstripe position (on the top or bottom of the card).
Back Side
If Duplex mode is enabled (in Setup), this button can be used to switch the ‘Options’ dialogue to back side, to set the options for the back of the card. The dialogue for the back will look as follows:
Quick Start Guide
The same options can be set as for the front. With the ‘Front Side’ button, the user can switch back to the front. Note that in Duplex Mode the options ‘Back Side Only’, ‘Manual Flip Mode’ and ‘Magstripe Only’ are not applicable and therefore not available.
Hand Fed Mode - If this switch is checked the printer will not feed a card from the hopper but will allow the operator to insert a card from the front. It the card is not inserted within 20 seconds when prompted then the printer will return to standby.
Back Side Only - This option will only work on Magicard Flip models as they have the ability to print double sided cards. The image will allow a magnetic stripe card to be encoded and printed on the back only. `
Manual Flip Mode - Allows operators, running
Magstripe Only - For magnetic encoding models only. Checking this box will prevent any printing on the card, but will encode on the magstripe only.
Color
MAGICARD TURBO Color Printer | Page 25 |