
Quick Start Guide | Ultra Electronics Card Systems |
Mechanism
Top Cover
Dye Film
Carrier
Dzus Fastener
Thermal
Printhead
4.Whilst changing the dye film, and with the dye film removed, gently wipe the tip of the Thermal Printhead, using a gentle
5.Using a tissue, remove any deposits from the pen tip and replace the pen cap to avoid solvent evaporation. Allow the solvent to evaporate fully from the printhead before proceeding to fit the new roll of dye film.
Cleaning the Tacky Roller
NOTE - It is very important that these Cleaning Instructions are adhered to in order to maintain the MagiCard print quality.
A Tacky Roller is located between the Cassette and the upper brushstrip. Its purpose is to pick up loose debris, fibres and particles from the upper surface of each card which would otherwise cause a blemish on the finished printed card. Depending on the type of cards used it is recommended that the Tacky Roller is cleaned each time the Card Cassette is filled, to recover its stickiness. Clean the Tacky Roller using a piece of Scotch adhesive tape. Refer to Section E to see how to remove the Tacky Roller.
Cleaning the Rubber Rollers
It is recommended that the Rubber Rollers in the transport mechanism be cleaned after every 1000 cards printed, using the recommended
CAUTION: Failure to clean the Rubber Rollers may result in
WARNING The recommended cleaning materials are inflammable. Clean the Thermal Printhead in a
Page 30 | MAGICARD TURBO Color Printer |