Ultra Electronics Card Systems | Quick Start Guide |
Important Cleaning
Procedures P
It is very important that the MagiCard Printer be cleaned at regular intervals in accordance with these instructions. Cleaning Cards and a Cleaning Pen are included with every printer shipped.
Thermal Printhead Cleaning
It is recommended that the Thermal Printhead be cleaned after every roll of dye film, i.e. after every 250 cards printed.
CAUTION Failure to clean the Thermal Printhead after every roll of dye film can result in the build up of residues which cause white lines and streaks in the printed image. The Thermal Printhead is a fragile and expensive item. Care should be taken to avoid damage to the printing surface at its lower edge. The surface of the Thermal Printhead should not be touched with the fingers and under no circumstances should any hard, sharp or abrasive materials be allowed to contact it.
WARNING The recommended cleaning materials are inflammable. Clean the Thermal Printhead in a
Clean the Thermal Printhead as follows:
1. Switch the printer OFF and isolate from the mains power supply.
WARNING The MagiCard Printer contains potentially lethal voltages.
2.Release the top cover catch on the
3.Lift up the Top Cover to the vertical position, as illustrated.
MAGICARD TURBO Color Printer | Page 29 |