Ultra electronic Turbo MS quick start Micro Switch

Page 31

Ultra Electronics Card Systems

Quick Start Guide

1.Lift up the Top Cover to the vertical position, and remove the Cassette. Switch ON the power supply.

2.Get the motor to turn the rollers by operating the Microswitch in the front of the print engine, by hand. Allow the motors to achieve full operating speed before applying the Cleaning Card to the rollers, otherwise the motors will stall and the rollers fail to turn.

3.Clean the Front Rubber Drive Roller every 1000 cards printed or if mis-registration occurs. Open a fresh solvent impregnated Cleaning Card and clean the Front Rubber Drive Roller by inserting the Cleaning Card from the front with the impregnated side faced down, with the rollers turning so that the roller turns against the Cleaning Card as shown in Position A.

4.Clean the Printhead Roller, normally positioned beneath the Thermal Printhead, by applying the Cleaning Card (with the impregnated side faced down) to the visible surfaces of the Printhead Roller so that the roller turns against the Cleaning Card as shown in Position D.

NOTE Discard the Cleaning Card when it has dried out. One or two cards should be sufficient to carry out these instructions.

5.Clean the Rear Rubber Drive Roller by inserting the Cleaning Card with the impregnated side faced down, from the rear with the rollers turning (ie, beneath the Card Preventer and the Sticky Roller) so that the lower roller turns against the Cleaning Card as shown in Position E.

6.Clean the Card Feed Rollers every 1000 cards printed or if problems occur with cards feeding from the Cassette. Using the Cleaning Card clean the two Card Feed Rollers. One is normally beneath the Card Cassette and the other is close to theSticky Roller.

These rollers are geared together and cannot be turned by operating the Microswitch as above. Turn one Card Feed Roller by hand whilst applying the Cleaning Card, with the impregnated side faced down, to the other Card Feed Roller. Repeat the cleaning process for the other Card Feed Roller as shown in Positions B and C.

Micro

Switch

MAGICARD TURBO Color Printer

Page 31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Quick Start Guide for Magicard Turbo Color PrinterConventions Load the supplied Windows Driver softwareLocation Requirements for your printer Preparing a Location For the PrinterRemoving the Printer From the Box Checking Package Contents C Optional Starter KIT Recesses Install Dye Film DQuick Start Guide Ultra Electronics Card Systems Ultra Electronics Card Systems Quick Start Guide Load Plastic Cards Cleaning the Card Cleaning Roller sticky or tacky roller Connect the Printer To a Power Supply Test Printer Operation H Install the parallel Interface Cable I and Ultra Secure Key Procedure to be followed if your PC uses Windows Install Windows Driver JQuick Start Guide Ultra Electronics Card Systems Printer Setup Printer SetupInitialise the Setup Colour Format / Film Card Settings Colour Adjust Non-ECP Operation Which Mode Should I UseECP Operation Install the Windows Driver Install Windows NT4 DriverProcedure to be followed if your PC uses Windows NT Select Document defaults... from the File menu Printer SetupSetup Please note Overcoat SettingsOptions Data Transfer FormatDegree Rotation Film Power SettingUltra Secure Feature Black Format OptionsProperties Verifying Computer to Printer Communication in Windows M Case Difficulty Check the InstallationFor Further Assistance Thermal Printhead Cleaning Important Cleaning Procedures PCleaning the Rubber Rollers Cleaning the Tacky RollerMicro Switch Cleaning the Magnetic Head if fitted Cleaning the OpticsLED Error Codes Q Canadian Department of Communications Statement Limited Warranty Information EC Declaration of Conformity Ultra Electronics Ocean Systems Coles
Top Page Image Contents