Quick Start Guide | Ultra Electronics Card Systems |
Setting up your MAGICARD TURBO Color Printer takes just three easy steps:
1. Unpack and install the printer
APreparing a Location for the Printer
BRemoving the Printer from the Box
CChecking the Package Contents
DInstall the Dye Film
ELoad the Plastic Cards
FCleaning the Card Cleaning Roller (sticky or tacky roller)
GConnect the Printer to a Power Supply
HTest the Printer Operation
IInstall the Parallel Interface Cable and Ultra Secure Key
2. Load the supplied WINDOWS Driver software.
Jx | Install the WINDOWS Driver (WINDOWS 3.x) |
Jy | Install the WINDOWS Driver (WINDOWS 95) |
KPrinter Setup
LInstall the WINDOWS Driver (WINDOWS NT4)
3.Verify computer-to-printer operation.
MVerifying Computer to Printer Communication in WINDOWS
NIn Case of Difficulty.
PImportant Cleaning procedures.
QLED Error Codes
Note: The Ultra WEB site at http://www.ultra.co.uk contains comprehensive technical support information including the latest downloadable software, WINDOWS Drivers, Technical Bulletins etc
Conventions
Throughout this guide, the following conventions are used to identify important information.
WARNING - Warning messages indicate where personal injury could result from not following the correct procedures.
CAUTION - Caution messages indicate where damage to equipment could result from not following the correct procedures.
NOTE - Notes convey important information that is identified within the text.
Page 2 | MAGICARD Color Printer |