Volume/Tone Push Button
The Volume/Tone Push Button also performs multiple functions depending upon the duration of time it is pressed:
|
|
|
| Volume changes made using the Volume/Tone Push Button are lost | ||
|
|
|
| when the scanner is | ||
|
|
|
| ting. If you wish to permanently change the volume, use the special | ||
|
|
|
| |||
NOTE | programming labels in the Product Reference Guide. | |||||
|
| |||||
Table | ||||||
|
|
|
|
|
| |
PRESS | FUNCTION | COMMENT | ||||
DURATION | ||||||
|
| |||||
|
|
|
|
|
| |
|
|
|
|
|
| |
Momentary (when | Wakes scanner from Sleep | Alternatively, the scanner can be awakened by: | ||||
- Moving an object through the scan zone. | ||||||
scanner is asleep) | Mode | |||||
- Scanning with an attached auxiliary scanner. | ||||||
|
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
| Press the push button momentarily to increase speaker | |
Momentary (when |
| volume. When the loudest volume is reached, a | ||||
Increments volume | repeated press of the push button cycles volume back | |||||
scanner is awake) | ||||||
| to the lowest setting, then volume increases on subse- | |||||
|
|
|
|
| ||
|
|
|
|
| quent press(es). Four volume levels are available. | |
|
|
|
|
|
| |
Hold, then release |
| Press the push button for approximately 2 seconds, | ||||
| then release. Each time this is done, the beeper will | |||||
when the beeper | Increments tone | |||||
sound at one of three tones. Stop when the desired | ||||||
sounds |
| |||||
| tone (high, medium or low) is sounded. | |||||
|
|
|
|
| ||
|
|
|
|
|
| |
|
|
|
|
| This mode allows system support personnel to trouble- | |
|
|
|
| Scanner Diagnostics Modea | shoot problems with the scanner and is used to deter- | |
4 Seconds | mine if it can read bar codes. Press the button for eight | |||||
|
|
|
|
| seconds or cycle power to exit Scanner Diagnostics | |
|
|
|
|
| Mode and reset the scanner. | |
|
|
|
|
|
| |
8 Seconds | Resets Scannerb | Only system support personnel should perform a reset. |
a.By standard default, this function is normally disabled to prevent accidental activation by users.
b.Users should not perform scanner resets except under the direction of trained systems support person- nel.
Quick Reference Guide | 3 |