Raymarine manual Pathfinder Radar Scanners

Page 34

26	Pathfinder Radar Scanners

ing on the thickness of the cable: use the position that matches the profile of the cable.

CAUTION:

It is essential that the drain tube is fitted and that the nut on the watertight gland is adequately tightened. If this is not done, water could become trapped in the scanner and cause irreparable damage.

13.Tighten the securing nut (1) again to ensure a waterproof seal.

14.If you have a 4D scanner, replace the inner cover over the connec- tors.

15.Untie the cord from the scanner cover, and coil it up in the base of the scanner unit so that it cannot foul the rotating antenna.

16.Replace the scanner cover, aligning the mark on the cover with the mark on the scanner base above the cable gland, and tighten the 4 or 7 captive screws. Do not over-tighten these screws.

Image 34

Contents Pathfinder Radar Scanners Page Pathfinder Radar Scanners Owners Handbook OctoberPathfinder Radar Scanners Preface Display Software VersionWarranty Contents Appendix a Overview IntroductionEMC installation guidelines This handbook is divided into three chapters as followsConnections to Other Equipment Supplied with For Unpacking and inspecting the componentsOption Supplied with Option forSelecting the scanner unit site Radome Scanner Weight Open Array ScannersPathfinder Radar Scanners Mounting surface power boats Mounting surface sailboatsSetting the radiation plane Ideal Radiation PlaneCable runs Rejoining CablesInter-unit cable Scanner Package Inter-Unit CableInter-Unit Cable Scanner Package Radome scanner cables2DE Eur Power cable Radome Scanner Inter-Unit Cables32 V Systems 4 kW scanners Open array scanner cablesSystems 4 kW scanners only Inter-Unit Cable KW Scanners32 V Systems 10kW scanners Power Cable Core Size each core 32 V systemsKW Scanners Pathfinder Radar Scanners Installing the Scanner Connecting the radome scanner inter-unit cable Inner cover White wire Installing the Scanner Pathfinder Radar Scanners Open array scanner Securing the pedestal to the mounting platform Connecting the open array scanner inter-unit cable Heatshrink Heat Shrinking of Wires Do not grease the gasket in the pedestal lid Fitting the open array to the pedestal System connections DC power connectionPower Connections Grounding the radar systemScanner connection Vessels Device Open Array Systems Radome Supply 10 kWDisplay Front view Display Cable ConnectorScanner Connector Panels Display unit connectionPathfinder Radar Scanners System Checks and Alignment Set up, alignment and timing checksSwitch on and initial set up EMC ConformanceChecking transmission Display timing adjustmentOpen array position alignment Bearing alignmentServicing and Safety MaintenanceRoutine Checks Problem Solving Problem CorrectionFor Accessories and Parts How to Contact Raytheon USFor Marine Product and Services Information For Technical SupportHow to Contact Raytheon Europe For Product Repair and ServiceWorldwide Support Accessories and PartsTechnical Support Pathfinder Radar Scanners Transmitter 2D 18 Radome Scanner UnitGeneral Antenna4D 24 Radome Scanner Unit ReceiverIncluding Low Noise Converter/Limiter & if Receiver 5S and 9S 48 Open Array Scanner Unit Pulse Length/PRFAppendix a Specification 9S Transmitter 10 kWReceiver Noise Figure Less than 5 dB 7S and 11S 72 Open Array Scanner Unit 7S Transmitter 4 kW11S Transmitter 10 kW Appendix a Specification Pathfinder Radar Scanners Index Pathfinder Radar Scanners