Raymarine Radar Scanner manual Heatshrink

Page 38

30	Pathfinder Radar Scanners

3.Referring to the following illustration, remove the cable gland nut, washer and grommet from the watertight gland, where the inter-unit cable will enter the base.

	Heatshrink
5mm (0.2in)	5mm (0.2in)
20mm (0.8in)	20mm (0.8in)
40mm (1.6in)
	D4575-2

4.Slide the cable through the gland nut, washer and grommet, then into the base. Clamp into position, ensuring the section of main cable covered in yellow heat shrink is clamped.

5.The cable is supplied prepared and ready to fit to the signal and power connectors. If you need to cut the cable to length, strip off the protective outer sleeve then use the supplied kit to prepare the cable as detailed in the following illustration

Image 38

Contents Pathfinder Radar Scanners Page Pathfinder Radar Scanners Owners Handbook OctoberPathfinder Radar Scanners Preface Display Software VersionWarranty Contents Appendix a Overview IntroductionEMC installation guidelines This handbook is divided into three chapters as followsConnections to Other Equipment Supplied with For Unpacking and inspecting the componentsOption Supplied with Option forSelecting the scanner unit site Radome Scanner Weight Open Array ScannersPathfinder Radar Scanners Mounting surface power boats Mounting surface sailboatsSetting the radiation plane Ideal Radiation PlaneCable runs Rejoining CablesInter-unit cable Scanner Package Inter-Unit Cable2DE Eur Radome scanner cablesInter-Unit Cable Scanner Package Power cable Radome Scanner Inter-Unit Cables32 V Systems 4 kW scanners Open array scanner cablesSystems 4 kW scanners only Inter-Unit Cable KW Scanners32 V Systems 10kW scanners Power Cable Core Size each core 32 V systemsKW Scanners Pathfinder Radar Scanners Installing the Scanner Connecting the radome scanner inter-unit cable Inner cover White wire Installing the Scanner Pathfinder Radar Scanners Open array scanner Securing the pedestal to the mounting platform Connecting the open array scanner inter-unit cable Heatshrink Heat Shrinking of Wires Do not grease the gasket in the pedestal lid Fitting the open array to the pedestal System connections DC power connectionPower Connections Grounding the radar systemScanner connection Vessels Device Open Array Systems Radome Supply 10 kWScanner Front view Display Cable ConnectorDisplay Connector Panels Display unit connectionPathfinder Radar Scanners System Checks and Alignment Set up, alignment and timing checksSwitch on and initial set up EMC ConformanceChecking transmission Display timing adjustmentOpen array position alignment Bearing alignmentRoutine Checks MaintenanceServicing and Safety Problem Solving Problem CorrectionFor Accessories and Parts How to Contact Raytheon USFor Marine Product and Services Information For Technical SupportHow to Contact Raytheon Europe For Product Repair and ServiceTechnical Support Accessories and PartsWorldwide Support Pathfinder Radar Scanners Transmitter 2D 18 Radome Scanner UnitGeneral Antenna4D 24 Radome Scanner Unit ReceiverIncluding Low Noise Converter/Limiter & if Receiver 5S and 9S 48 Open Array Scanner Unit Pulse Length/PRFAppendix a Specification 9S Transmitter 10 kWReceiver Noise Figure Less than 5 dB 7S and 11S 72 Open Array Scanner Unit 7S Transmitter 4 kW11S Transmitter 10 kW Appendix a Specification Pathfinder Radar Scanners Index Pathfinder Radar Scanners