Trango Broadband M5580M-FSU Opmode su y / off, Set defaultopmode su off, Gateway, Tftpd on off

Configuration

	to execute commands from the	#>Set suid 3
	AP to this specific SU.
AP ID	Informational parameter that	Informational Parameter
	shows to which AP the SU is
	associated. Please note that
	AP ID is not used by the
	system for SU authentication.
Opmode	Current Opmode of radio.	opmode su [< y>] / off
		This sets the radio in Opmode “SU.” Or OFF
Default Opmode	Determines the Opmode (“SU”	set defaultopmode <su off>
	or “OFF”) of the radio after
	reboot/power cycle. When the	Example: #>set defaultopmode ap
	parameter is set to “SU,” the
	radio will progress into
	Opmode “SU” automatically
	fter reboot/power cycle.
IP	IP, Subnet, and Gateway	ipconfig [<new ip> <new subnet mask> <new
Subnet	address of radio.	gateway>]
Gateway		Example: #>ipconfig 10.1.1.3 255.0.0.0 10.1.1.1
TFTPD	TFTPD status (on or off).	tftpd [<on off>]
	TFTPD should be turned on to
	import file into radio (such as
	new firmware). Default is off.
	TFTPD will revert to off after
	reboot/power cycle.
RF TX Power	Current transmit power of the	power set <dBm> (Range is 7..21)
	SU not including antenna gain.
	This is controlled during the
	association process.
Channel Scan Sequence	Shows the various channels (in	freq scantable (displays scan table)
	sequence) that the SU will	freq scantable 5 v (sets	Scan table to 5 v)
	scan while searching for an
	AP.
Active Channel	Shows the channel used in the	Information Parameter
	current association, and
	"Associated" or
	"Disconnected" depending on
	the association status.
Broadcast Packet Filter	This software switch (0)	sw 0 [<on off>] (default is on)
	enables/disables the blocking
	of Ethernet control packets,	Example:
	except ICMP and ARP, to	#>sw 0 on
	reduce the amount of
	unnecessary overhead
	introduced to the wireless link.
Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2			page 11