Trango Broadband M5580M-FSU user manual Strain relief and boot installation, Mounting Hardware

Page 26

Deployment & Installation

Strain relief and boot installation

Prior to deployment, insert a properly terminated Cat-5 Cable through Boot and the Foam strain relief. Connect the Cable into the M5580M-FSU’s port opening. Last, clip the front end of the boot into the unit and then clip the back end of the boot into to the unit, as shown in the photographs below.

Figure 15

Figure 16

Mounting Hardware

Radios are supplied with mounting hardware for pole and antenna dish installations. See figure 17 - 21 below for proper use of the mounting hardware.

Figure 17

Figure 17: M5580M – FSU Series SU Pole Mount (1” – 2” Diameter)

Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2

page 22

Image 26

Contents February 13 Revision For Firmware V.2p0r8 Appendix B FCC Information Warranty InformationPreface Overview Range vs. Throughput System Contents Location of Serial Number & MAC Address Location of RJ-45/LED Port Connections and Power Getting StartedTelnet ip address of radio Configuration ToolsTroubleshooting Ethernet Connections System Information sysinfo # sysinfoAccess Point Basic Settings ConfigurationEssentials to Establish a Wireless Link Key ConceptsSet baseid baseid Set suid suidPower set dBm Range is Set defaultopmode su offIpconfig new ip new subnet mask new Sw 0 on off default is onEstablishing a Wireless Link Changing IP Address LEDsPower Settings Using the Http Interface Configure Basic ParametersConfigure Basic Configure Basic Configure Basic Continuo Site survey Deployment & InstallationSite Selection Rssi Command and Antenna Alignment Channel PlanningRF Link Loopback Test linktest command Strain relief and boot installation Mounting HardwareM5580M-FSU Series SU Wall Mount M5580M FSU / AD5800 -25 Reflector Dish on Pole Cabling and Weather Considerations WeatherizingSnmp Firmware Upgrade Procedure Example #tftpd onCommand RemarksAppendix a Specifications Data Parameters