Configuration
AP Autoscan | Software switch (1) is to | sw 1 [<on off>] (default is on) |
| turn AP autoscan on or off. |
|
|
|
|
TCP/IP for AP | Software switch (2), when on, | sw 2 [<on off>] (default is on) |
| allows users at the AP side |
|
| of the network to telnet or |
|
| HTTP into the SU. |
|
|
|
|
HTTP services | Software switch (5), when on, | sw 5 [<onoff>] (default is on) |
| allows local access via the |
|
| browser |
|
TCP/IP for Local Ethernet | This software switch (switch |
|
| 6) when on, allows users on | sw 6 [<on off>] (default is on) |
| the wired side of the SU to |
|
| telnet or HTTP into the SU. |
|
|
|
|
Remarks | User definable radio | remarks [<remarks>] |
| information (i.e. customer | Example: |
| name, address of installation, | #>remarks 678 Oak Ave |
| and so on). Stores a |
|
| maximum of 28 |
|
| characters can be stored. |
|
|
|
|
Counters: | These are averages of wired | Informational Parameter |
RF TX RF RX | and wireless, transmit and |
|
Eth TX Eth RX | received, traffic in Kbps. |
|
|
|
|
Establishing a Wireless Link
If the AP and SU are properly configured and in opmode “ON”, the two radios will automatically begin the authentication process and become connected. To determine if the two radios are connected, type the sysinfo command.
Example:
#> sysinfo
[Hardware Version] 5580
[MVC Version] 3893mvc_4p5_050913.arm
[Firmware Version] FSU 2p0r8D06011801
[Device ID] 00 01 DE 00 04 47 [Base ID] 1 [AP ID] 1 [SU ID] 1 [System Up Time] 0 day(s) 00:34:15
[Opmode] off [Default Opmode] off [Opmode Start] 30 sec
[IP] 192.168.100.100 [Subnet Mask] 255.255.255.0 [Gateway] 192.168.100.1 [Httpd Port] 80 [Httpd Status] listen
[Telnetd Port] 23 [Telnetd Status] connected [Telnet Client #1] 192.168.100.111,1092 [Tftpd] disabled
[RF Tx Power] 21 dBm
Channel Table: (MHz)
[Ch#01] 5736 [Ch#02] 5756 [Ch#03] 5776 [Ch#04] 5796 [Ch#05] 5816 [Ch#06] 5836
[Ch#07] 5736 [Ch#08] 5736 [Ch#09] 5736 [Ch#10] 5736 [Ch#11] 5736 [Ch#12] 5736
[Ch#13] 5736 [Ch#14] 5736 [Ch#15] 5736 [Ch#16] 5736 [Ch#17] 5736 [Ch#18] 5736
[Ch#19] 5736 [Ch#20] 5736 [Ch#21] 5736 [Ch#22] 5736 [Ch#23] 5736 [Ch#24] 5736
[Ch#25] 5736 [Ch#26] 5736 [Ch#27] 5736 [Ch#28] 5736 [Ch#29] 5736 [Ch#30] 5736
[Channel Scan Sequence] 1 h [Active Channel] 1 h Disconnected
[Broadcast Packet] on [Auto Scan AP] on [TCP/IP for AP] off [TCP/IP for Local Eth] off
Trango Broadband Wireless — | page 12 |