Trango Broadband M5580M-FSU user manual Location of RJ-45/LED Port

Page 9

Overview

Location of RJ-45/LED Port

The RJ-45 connector, diagnostic LEDs, and reset button are located at the bottom of the radio. Functionality of the LEDs is described later in this text. The reset button, resets all configuration settings (including IP address and password) back to factory default. Hold the reset button down for 5 seconds (until amber lights flash) while unit is powered on.

Figure 6

Reset Button

Trango Broadband Wireless — M5580M-FSU (Atlas Fox) User Manual Revision 2

page 5

Image 9

Contents February 13 Revision For Firmware V.2p0r8 Appendix B Warranty Information PrefaceFCC Information Overview Range vs. Throughput System Contents Location of Serial Number & MAC Address Location of RJ-45/LED Port Getting Started Connections and PowerConfiguration Tools Troubleshooting Ethernet ConnectionsTelnet ip address of radio # sysinfo System Information sysinfoEssentials to Establish a Wireless Link ConfigurationAccess Point Basic Settings Key ConceptsSet suid suid Set baseid baseidIpconfig new ip new subnet mask new Set defaultopmode su offPower set dBm Range is Sw 0 on off default is onEstablishing a Wireless Link LEDs Changing IP AddressPower Settings Configure Basic Parameters Using the Http InterfaceConfigure Basic Configure Basic Configure Basic Continuo Deployment & Installation Site SelectionSite survey Channel Planning Rssi Command and Antenna AlignmentRF Link Loopback Test linktest command Mounting Hardware Strain relief and boot installationM5580M-FSU Series SU Wall Mount M5580M FSU / AD5800 -25 Reflector Dish on Pole Weatherizing Cabling and Weather ConsiderationsSnmp Example #tftpd on Firmware Upgrade ProcedureRemarks CommandData Parameters Appendix a Specifications