Topcom 510, 500, 520 manual Filter Number Selection, Setting Ringing Tone and Volume

HL_DM5201_GB.qxd 16-04-2003 13:24 Page 25

Deskmaster

•Select a register (1 of 5) and enter the phone number required.

Filter

132 Number

Number

3 :

Number

3 : 0123456_

Filter

132 Number

Filter

131 selection

By specifying the filter type, you can define, whether the programmed numbers should be signalled by the audible ringer or not.

The following functions are available:

Menu

Function

Filter Off	• The filtering on barring of caller IDs will be switched OFF.
Filter On	• Only calls of one of the phone numbers programmed will be signalled by
	an audible alarm. All other calls are only indicated on the phone display.
Filter Barring On	• Calls received from one of the phone numbers programmed will not be
	signalled by an audible alarm. The call will only be indicated on the
	display. All other calls will be signalled by an audible alarm.

Note : The “Quiet” function is also available from the menu structure. This function disables the audible signalling

for all calls.

10.3 Setting Ringing Tone and Volume

You can select the loudness and the melody for incoming calls to the phone. With several phones in one room, the calls can thus be distinguished acoustically. The loudness can be set to increase auto- matically step by step to the maximum. This function can be disabled.

The following ringing tones can be configured:

•MSN : Up to 3 different “Multible Subscriber Numbers” (MSNs) can be configured for your phone. Each can have an individual ringing tone programmed.

(See also section “Programming MSNs”)

•Special Ringing Tone : Up to 3 Caller ID’s can be programmed to be indicated by a special ringing tone.

25