3.2Menu System Layout
The front panel menu system is as follows:
RS-210 Main Menu
∙Ethernet Setup
§Set IP Config
§Static
§IP
§Subnet Mask
§Gateway
§DHCP
§BOOTP
§RARP
§None
§No Change (Exit)
§Restart Network
§Show Current Config
§Exit Menu
∙Manual Shutdown
§Power off System?
∙Exit Menu
3.3Ethernet Setup
The RamSan-210 uses both a serial port and an Ethernet port to allow you to monitor and configure the system. To access the system’s Ethernet port, the RamSan must be assigned an IP address, subnet mask, and possibly a gateway. The IP address may be assigned in one of five ways: Static IP, DHCP, BOOTP, RARP, or No Ethernet.
To setup the Ethernet, use the arrow buttons to cycle through the top-level menu options until “Ethernet Setup” is showing on the display. Use the “Select” button to choose this option and continue with the configuration. You may now use the arrow buttons to scroll through the following menu options: “Set IP Config”, “Restart Network”, “Show Current Config”, and “Exit Menu”. “Restart Network” will shutdown and restart the Ethernet port using the current IP assignment configuration. Selecting “Show Current Config” will display a list of the current IP configuration, hostname, IP address, subnet mask, gateway address (if applicable), and hardware Ethernet address. Use the arrow buttons to scroll up and down through the list. Pressing the “Menu” button will return to the previous menu, and pressing the “Select” button will exit the menu system. To continue setting up the Ethernet configuration, select “Set IP Config”.
- 11 -
