Texas Memory Systems RamSam-210 user manual

Page 28

The following steps should be performed to hot swap a fan block:

1.Slide the latch on the fans to the left and simultaneously pull firmly on the fan handle. The unit will slide out from the chassis. Use caution to avoid hitting the spinning fan blades once removed.

2.Firmly insert the new fan block into the RamSan-210 chassis. The fans will begin immediate operation once inserted into the chassis.

Important:

Failed fans should be replaced as soon as possible.

- 23 -

Image 28
Contents Texas Memory SYSTEMS, INC Page Table of Contents Reset Status Figures Document Overview PrefaceConventions Overview IntroductionSystem Components Power Requirements Non-VolatilityPage Installation Battery WarningElectro-Static Discharge Warning System InspectionRamSan-210 Layout Connecting the Power Supplies Connecting the Fibre Channel PortsRack Mounting On switch Low Voltage Battery Turning on the System System InitializationUsing the Front Panel RamSan-210 Front PanelEthernet Setup Menu System LayoutManual Shutdown System Monitoring Page Connecting to the MCP Connecting using a terminal programConnecting using telnet Management Control Port MCPExit MCP CommandsHelp Page Lunconfig ManageReboot ResetStatus Hot Swapping Power Supplies Hot Swap ComponentsHot Swapping Disk Drives Hot Swapping FansPage Batteries Troubleshooting Specifications Physical CharacteristicsWarranty Operating EnvironmentAppendix a RamSan-210 Replacement Parts Figure B-1 MCP31 Management Control ProcessorFigure B-3 PWR21 Power Supply Module Figure B-6 TDD21 18 gigabyte replacement hard drive