Texas Memory Systems RamSam-210 user manual Status

Page 25

4.5.14STATUS

The “STATUS” command provides a variety of configuration details for the MCP and the Fibre Channel controllers.

ram-san> status
Texas Memory Systems, Inc.
RamSan-210 Monitor
Software Version:	1.0.1
Ethernet address:	00:20:c2:00:08:05
Ethernet IP:	192.94.231.206
Capacity:	4096 Megabytes
System Status: System Idle
FC32 Controller 1	-- Not installed
FC32 Controller 2	- Firmware version: 0.9d
Channel A: 10:02:00:20:c2:00:08:03		offline
Channel B: 11:02:00:20:c2:00:08:03		offline

- 20 -

Image 25

Contents Texas Memory SYSTEMS, INC Page Table of Contents Reset Status Figures Document Overview PrefaceConventions Overview IntroductionSystem Components Non-Volatility Power RequirementsPage Battery Warning InstallationElectro-Static Discharge Warning System InspectionRamSan-210 Layout Connecting the Power Supplies Connecting the Fibre Channel PortsRack Mounting On switch Low Voltage Battery System Initialization Turning on the SystemRamSan-210 Front Panel Using the Front PanelMenu System Layout Ethernet SetupManual Shutdown System Monitoring Page Connecting using a terminal program Connecting to the MCPConnecting using telnet Management Control Port MCPExit MCP CommandsHelp Page Manage LunconfigReset RebootStatus Hot Swap Components Hot Swapping Power SuppliesHot Swapping Fans Hot Swapping Disk DrivesPage Batteries Troubleshooting Physical Characteristics SpecificationsWarranty Operating EnvironmentFigure B-1 MCP31 Management Control Processor Appendix a RamSan-210 Replacement PartsFigure B-3 PWR21 Power Supply Module Figure B-6 TDD21 18 gigabyte replacement hard drive