Schlage user manual SRP-275 Changing the paper width

Page 30

SRP-275

6. Changing the paper width

Screw(3x6)(2pieces)

Frame paper control

57.5mm 69.5mm 76mm(default)

1)Open the rear cover.

2)Remove the frame paper control by loosing the two screws(3×6).

3)Reattach the frame paper control in you want. (Insert and tighten two screws(3×6) to reattach.)

4)Close the rear cover.

5)Change the Memory Switch setting for changing paper roll width. (See the instructions "Setting the Memory Switches"(3.1) in Chapter 3.)

Rev. 1.01

- 30 -

Image 30
Contents SRP-275 SRP-275 Safety Precautions Do not plug several products in one multi-outletSRP-275 To UnplugSRP-275 Waste Electrical and Electric Equipment Weee SRP-275 EMC and Safety standards AppliedCE Marking Label MaterialSRP-275 Introduction Front viewRear view SRP-275 Table of Contents SRP-275 Setting Up the Printer UnpackingChoosing a place for the printer Error LED Red Color Using the operation panelControl panel Power LED Green Color Paper OUT LED Red ColorConnecting the Interface cable and Drawer kick-out cable SRP-275 Connecting the cablesConnecting the AC Adaptor Connect the AC adapter according to the following procedureSerial Interface RS-232C Interface connectorConnector Drawer kick-outPin no Source Compatibility mode Nibble mode Byte mode Parallel Interface IEEE1284Drawer kick-out USB InterfaceEthernet Interface Pin No Description DirectionSRP-275 Setting the Switches Setting the DIP SwitchDIP Switch setting for EpsonESC/POS mode DIP Switch setting for CitizeniDP 3550 mode International Character Selection DSW Code CountryDIP Switch setting for StarSP500 mode Emulation Selection DSW 1-1Changing the DIP Switch setting Memory Switch Function Setting the Memory SwitchesMemory Switch setting for EpsonESC/POS mode OffCustomize value Function Selectable value Serial communication Function Selectable valueMemory Switch Setup Mode Example of Memory Switch setup sheetProcedure of Memory Switch setting Memory Switch setting for Star mode SettingsFunction Class Default Settings Function Memory Switch Bit DbcsMemory Switch Bit Function MSW 2-ACharacter Table *2 Memory Switch Bit Function Reserved SRP-275 Ribbon Cassette Installation SRP-275 Roll Paper Installation SRP-275 Changing the paper width SRP-275 Installing the wall mount Option SRP-275 Self Test To use the hexadecimal dump feature, follow these steps SRP-275 Hexadecimal DumpingHexadecimal dump Paper specifications SpecificationPrinting specification Ribbon cassette specificationElectrical characteristics ReliabilityEnvironment conditions Dimensions Dimensions & weightOptional features WeightRecoverable errors SRP-275 Appendix TroubleshootingError LED blinking pattern Error Description Error LED blinking pattern RecoveryPrinter does not start printing If any of the lights are on, please check the followingPrinting is poor Printer stops printingYou want to check the operation of the printer by itself Self test