Schlage user manual SRP-275 Installing the wall mount Option

Page 31

SRP-275

7. Installing the wall mount (Option)

Bracket mount

Screw(4x10)

(8pieces)

Bracket hanger

1)Turn the Set over and attach the Bracket hanger to the Frame base then tighten four screws.

Screw(3x5)

(4pieces)

2)Attach the Bracket mount to the wall firmly with the eight screws. Be sure that the Bracket attached properly to match the direction of arrow as shown. And the Bracket mount should be always fixed vertically.

3) Insert the Bracket hanger of Set to the Bracket mount as shown.

Rev. 1.01

- 31 -

Image 31

Contents SRP-275 Do not plug several products in one multi-outlet SRP-275 Safety PrecautionsTo Unplug SRP-275SRP-275 Label Material SRP-275 EMC and Safety standards AppliedCE Marking Waste Electrical and Electric Equipment WeeeFront view SRP-275 IntroductionRear view SRP-275 Table of Contents Unpacking SRP-275 Setting Up the PrinterChoosing a place for the printer Paper OUT LED Red Color Using the operation panelControl panel Power LED Green Color Error LED Red ColorConnect the AC adapter according to the following procedure SRP-275 Connecting the cablesConnecting the AC Adaptor Connecting the Interface cable and Drawer kick-out cableDrawer kick-out Interface connectorConnector Serial Interface RS-232CParallel Interface IEEE1284 Pin no Source Compatibility mode Nibble mode Byte modePin No Description Direction USB InterfaceEthernet Interface Drawer kick-outSetting the DIP Switch SRP-275 Setting the SwitchesDIP Switch setting for EpsonESC/POS mode International Character Selection DSW Code Country DIP Switch setting for CitizeniDP 3550 modeEmulation Selection DSW 1-1 DIP Switch setting for StarSP500 modeChanging the DIP Switch setting Off Setting the Memory SwitchesMemory Switch setting for EpsonESC/POS mode Memory Switch FunctionSerial communication Function Selectable value Customize value Function Selectable valueExample of Memory Switch setup sheet Memory Switch Setup ModeProcedure of Memory Switch setting Settings Memory Switch setting for Star modeFunction Class Default Settings Dbcs Function Memory Switch BitMSW 2-A Memory Switch Bit FunctionCharacter Table *2 Memory Switch Bit Function Reserved SRP-275 Ribbon Cassette Installation SRP-275 Roll Paper Installation SRP-275 Changing the paper width SRP-275 Installing the wall mount Option SRP-275 Self Test SRP-275 Hexadecimal Dumping To use the hexadecimal dump feature, follow these stepsHexadecimal dump Ribbon cassette specification SpecificationPrinting specification Paper specificationsReliability Electrical characteristicsEnvironment conditions Weight Dimensions & weightOptional features DimensionsError Description Error LED blinking pattern Recovery SRP-275 Appendix TroubleshootingError LED blinking pattern Recoverable errorsIf any of the lights are on, please check the following Printer does not start printingSelf test Printer stops printingYou want to check the operation of the printer by itself Printing is poor