71 for instructions. STEP 1 is complete.
No. | LCD display | Icon | TrunkingType | Special requirements |
1 | Type 2 800 | M | Motorola Type 2 800 MHz |
|
2 | Type 1 | M | Motorola Type 1 | a. Must program a fleet map. |
3 | Type 2 900 | M | Motorola Type 2 900 MHz |
|
4 | Type 2 UHF | M | Motorola Type 2 UHF | b. Must program base, spacing, |
5 | Type 2 VHF | M | Motorola Type 2 VHF | frequency and offset channel. |
| ||||
6 | EDCS WIDE | E | EDACS Wideband 9600 baud | c. Must program frequencies |
7 | EDCS NARROW | E | EDACS Narrowband 4800 baud | in exact order and location. |
| ||||
8 | EDCS SCT. | E | EDACS SCAT |
|
9 | LT | L | LTR |
|
Note: Information on APCO
STEP 2:
Programming Trunking Frequencies
After you finish selecting the bank and trunk type you want to track, store the frequencies in the channels for your selected bank in your scanner. Remember that you can only store one trunking system in each bank.
Important: If you are programming an EDACS or LTR trunked system, you must enter the frequencies in a specific order. Check the frequency guide included with the scanner for the frequencies in your area. For additional frequencies, check the web sites listed on page 11.
1. Press MENU/BACK.
2. Select 2:SCAN OPTION /
CH/
FRQ
HOLD/
MAN
RSM
2:TRUNK by rotating the VFO and
SCAN 
SERVICE 
SEARCH
MENU/BACK | TRUNK |
pressing E.
L/O
3. Select the bank number by rotating the | REVERSE |
VFO and pressing E. | . |
|
4.Select 2:TRUNK CHANNEL and
enter the channel number by rotating the VFO and pressing E.
SELECT
E
5.Select 1:FREQUENCY and enter a frequency for the trunked system using the keypad and pressing E.
6.Enter the alpha tag and press E. (See page 53).
7You can also change the step size in this menu.(See page 103)
Note: • To clear a mistake while entering the frequency,
50