Vanguard Managed Solutions 3400 Series manual Power Up Procedure, LEDs, Executing

Power Up Procedure

Power Up Procedure

Introduction	This section explains how to power up the Vanguard 3400 Series.
Procedure
	Follow these steps to power up your Vanguard 3400 Series.
	Step	Action
	1	Ensure that all the cards are fully inserted and secure.
	2	Ensure that the AC power cord is plugged in.
	3	Ensure the front panel power LED is on.
	To power down the Vanguard 3400 Series, unplug the power supply AC power cord
	from the power receptacle.
LEDs
	Figure 4-1shows the Vanguard 3400 Series LEDs and the table that follows
	describes them.

Power Stats

Figure 4-1. Vanguard 3400 Series LEDs

LED	Description		3400 Series System State
		Initial	Diagnostics	SW Loading	Operational
		PowerON	Executing		Status
Power	Power OK	On	On	On	On
Stats	Diagnostics/SW	On	Off	Blinking	On
	Loading

4-2 Powering Up Your Vanguard 3400 Series