Vanguard Managed Solutions 3400 Series manual FT1 and FE1 Daughtercard Connectors

Vanguard Networks Daughtercards

FT1/FE1 Daughtercards

Dual E&M Daughtercard

4-Port Voice FXS Daughtercard

The FT1/FE1 Daughtercards allow a Vanguard 3410 to transfer data over a T1 or E1 network. The daughtercards support full and fractional, channelized, T1 or E1, and PRI ISDN speeds.

•The E1 Daughtercard provides line rates 2.048 Mbps and data rates of n x 64 kbps (where n is 1 to 31) per channel.

•The T1 Daughtercard provides line rates 1.544 Mbps and data rates of n x 64 kbps (where n is 1 to 24) per channel.

Figure 2-8shows the T1 and the E1 Daughtercard connectors as they appear on the back panels. The T1 Daughtercard has a single RJ48C connector while the E1 Daughtercard has two BNC connectors along with one RJ48C connector.

\

T1 NTWK RX E1 NTWK TX

ALARM ALARM

Figure 2-8. FT1 and FE1 Daughtercard Connectors

Note
The E1 Daughtercard comes with this label	which specifies that the E1

interface complies with the Australian requirements ACA TS 016 - 1997 for connection to E1 SELV services. Also the E1 interface meets the IEC950 specifications for TNV1.

The Dual E&M Daughtercard has two E&M interfaces. The ports use RJ11 connectors.

Figure 2-9shows the Dual E&M Daughtercard connectors as they appear on the back panel.

E&M1 E&M2

LOC

REM

Figure 2-9. Dual E&M Daughtercard Connectors

The Vanguard Quad FXS Daughter Card is supported on the Vanguard 3460/3480. The 4-Port Voice FXS Daughtercard has four RJ11 connectors for four FXS Ports.

Figure 2-10shows the 4-Port Voice FXS Daughtercard connectors as they appear on the back panel.

.

FXS-1 FXS-2 FXS-3 FXS-4

Figure 2-10. FXS Daughtercard

2-8 Hardware Description