Vanguard Managed Solutions 3400 Series manual DB25 V.24 Pinouts DCE, Pin ITU Circuit Signal Name

Installing The Vanguard 3400 Series

This table describes the DB25 connector pinouts for port 1:

	DB25 V.24 Pinouts (DCE)
		Pin		ITU Circuit	I/O	Signal Name
	1			---	-----	Protective Ground
	2			103	INPUT	Transmitted data
	3			104	OUTPUT	Received data
	4			105	INPUT	Request To Send
	5			106	OUTPUT	Clear To Send
	6			107	OUTPUT	Data Set Ready
	7			102	-----	Signal Ground
	8			109	OUTPUT	Data Carrier Detect
	14			---	INPUT	Data Restraint Out
	15			114	OUTPUT	Transmitted Clock
	16			---	-----	N/C
	17			115	OUTPUT	Received Clock
	18			---	INPUT	External Rx Clock
	20			108/2	INPUT	Data Terminal Ready
	21			---	-----	N/C
	22			125	OUTPUT	Ring Indicator
	24			113	INPUT	External Tx Clock
	25			142	INPUT	Make Busy
Port 4
	This port has an RJ-45 connector. Use Port 4 as the CTP for Use Port 4 as the CTP
	for communicating with, configuring, monitoring, and for coldloading the node.
	Figure 3-5shows the pin numbers for port 4.
	Pin 1		Pin 8

Figure 3-5. Port 4 Pin Numbers

3-10 Installation and Replacement