Wasp Bar Code WLR8900 manual WLR 8900/8905 Programming Guide

Page 1

WLR 8900/8905

Programming Guide

Please Read

Note:

The Wasp WLR 8900/8905 Scanner is ready to scan the most popular bar codes out of the box. This manual should only be used to make changes in the configuration of the scanner for specific applications. This scanner does not require software or drivers to operate. The scanner enters data as keyboard data. Please review this manual before scanning any of the programming bar codes in this manual.

Tech Tip

If you are unsure of the scanner configuration or have scanned the incorrect codes, please scan the default bar code on page 6. This will reset the scanner to its factory settings.

Check Version

Image 1
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Factory Default & Keyboard Connection Autosense Stand ModeBeep and Delay Beep SettingsInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator/Code ID TerminatorEnable/Disable Bar Code Symbologies EnableDisableEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Ascii Table Appendix BAppendix B Ascii Character DEL Function Code for PC Appendix CAppendix D Technical SpecificationsProduct Support Frequently Asked Questions