Wasp Bar Code WLR8900 manual Frequently Asked Questions

Page 41

Frequently Asked Questions

Q: How do I configure the scanner for a notebook (or laptop) computer?

A: Scan the “Notebook” bar code on page 6.

Q: How do I change the terminator to a Tab?

A: Scan the “Tab” bar code on page 12.

Q: How do I remove the terminator?

A: Scan the “None” bar code on page 12.

Q: How do I enable the Full ASCII character set for the Code 39 bar code symbology?

A: Scan the following “Enable Code 39 Full ASCII” bar code on page 15.

38

Image 41
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Factory Default & Keyboard Connection Autosense Stand ModeBeep and Delay Beep SettingsInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator/Code ID TerminatorEnable/Disable Bar Code Symbologies EnableDisableEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Ascii Table Appendix BAppendix B Ascii Character DEL Function Code for PC Appendix CAppendix D Technical SpecificationsProduct Support Frequently Asked Questions