Wasp Bar Code WLR8900 manual Autosense Stand Mode, Factory Default & Keyboard Connection

Page 9

Chapter 5

Factory Default & Keyboard Connection

Factory Default

Use the Factory Default bar code to reset the scanner to the Default settings.

Factory Default

Autosense Stand Mode

Scan this Autosense Stand Mode bar code to enable the hands-free autosense feature of the WLR 8900/8905 Scanners. If you desire to turn this mode “off,” please scan the default bar code above.

Autosense Flash Mode

Enable

Keyboard Connection

The Keyboard Connection is used to program the Wasp WLR 8900/8905 Scanners for the type of computer it is attached.

PC - AT (PS/2) *

PC - XT

Notebook

*Default

6

Image 9
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Factory Default & Keyboard Connection Autosense Stand ModeBeep and Delay Beep SettingsInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator/Code ID TerminatorEnable/Disable Bar Code Symbologies EnableDisableEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Ascii Table Appendix BAppendix B Ascii Character DEL Function Code for PC Appendix CAppendix D Technical SpecificationsProduct Support Frequently Asked Questions