Wasp Bar Code WLR8900 manual Preamble/Postamble Configuration

Page 14

Chapter 5

Preamble/Postamble Configuration

The ‘Preamble/Postamble’ configuration is used to add a prefix or suffix set of characters to the bar code value. Up to 8 characters may be added for each option separately. Preamble and postamble characters can function concurrently, but need to be configured separately.

To add preamble or postamble characters, follow the steps below:

1)Scan the ‘Clear Pre/Postamble’ bar code on this page.

2)Scan the ‘Preamble’ or ‘Postamble’ bar code.

3)Use Appendix B on pages 31-34 to locate the characters you want to add as preamble or postamble characters. Make sure that you scan the bar code associated with each letter before preceding to the next character. For example, to add the letter “A,” scan the bar code corresponding to the letter “A” on page 33. The letter “A” will always appear in your data as prefix or suffix to the bar code value.

4)Scan the corresponding 'Pre/Postamble' bar code on this page to exit this setting.

Clear Pre/Postamble

Preamble

Postamble

11

Image 14
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Autosense Stand Mode Factory Default & Keyboard ConnectionBeep Settings Beep and DelayInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator Terminator/Code IDEnableDisable Enable/Disable Bar Code SymbologiesEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Appendix B Ascii TableAppendix B Ascii Character DEL Appendix C Function Code for PCTechnical Specifications Appendix DProduct Support Frequently Asked Questions