Wasp Bar Code WLR8900 manual Quick Start

Page 7

Chapter 4

Quick Start

Your Wasp WLR 8900/8905 Scanners are ready for use. The default settings of the scanners have been pre-programmed for the most common bar code configurations. Use the “WLR 8900/8905 Setup & Configuration” sections only to customize the scanners settings. Please review the “Enable Bar Code Symbologies” configuration beginning on page 14 to see the list of bar codes symbologies which are enabled by default.

Tip:

Use the pre-printed “Bar Code Test Symbols” in Appendix A on pages 28-30 as a test chart to practice scanning.

PS2 Connection

BACK OF PC

WLR 8900 PS2 Scanner

USB Connection

KEYBOARD MOUSE

DO NOT PLUG

IN MOUSE PORT!

KEYBOARD

Y-CABLE

WLR 8905

 

USB Scanner

KEYBOARD

USB Connector

4

Image 7
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Factory Default & Keyboard Connection Autosense Stand ModeBeep and Delay Beep SettingsInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator/Code ID TerminatorEnable/Disable Bar Code Symbologies EnableDisableEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Ascii Table Appendix BAppendix B Ascii Character DEL Function Code for PC Appendix CAppendix D Technical SpecificationsProduct Support Frequently Asked Questions