Wasp Bar Code WLR8900 manual Installation

Page 6

Chapter 3

Installation

WLR 8900 PS2

Scanner

Trigger

Scanning Aperture

Din-6M

Din-6F

1.Turn off your computer.

2.Unplug your PC keyboard cable and plug the male end (Din 6) of the WLR 8900 Scanner directly into your PC keyboard port. Plug your keyboard cable into the other end (female Din 6) of the the scanner.

3.Turn your computer on.

WLR 8905 USB

Scanner

Trigger

Scanning Aperture

USB Port

1.Plug the USB of the WLR 8905 Scanner directly into your PC’s USB port.

3

Image 6
Contents WLR 8900/8905 Programming Guide Page Table of Contents Introduction Bar Code Symbologies Installation Quick Start Setup & Configuration Autosense Stand Mode Factory Default & Keyboard ConnectionBeep Settings Beep and DelayInterblock Delay Upper/Lower Case Keyboard Language Preamble/Postamble Configuration Terminator Terminator/Code IDEnableDisable Enable/Disable Bar Code SymbologiesEAN Code 39 Settings Interleaved 2 of 5 and Code 93 Settings Code 128 and UCC/EAN 128 Settings MSI Plessey Settings Codabar Settings UPC-A Settings UPC-A Supplement Settings / UPC-A to EAN-13 UPC-E Settings UPC-E Supplement Settings EAN-8 Settings EAN-8 Supplement Settings EAN-13 Settings EAN-13 Supplement Settings Bar Code Test Symbols UPC-A EAN/JAN-13 Appendix B Ascii TableAppendix B Ascii Character DEL Appendix C Function Code for PCTechnical Specifications Appendix DProduct Support Frequently Asked Questions