●Inspect machine and replace worn or damaged parts.
●Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Remove the remainder using a
1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.
2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.
3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.
●Inspect machine and replace worn or damaged parts.
●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).
●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.
PRE-OPERATION CHECK LIST
(OWNER'S RESPONSIBILITY)
The operator should perform the following check list before operating the backhoe.
___ Check that backhoe is properly and securely attached to tractor.
___ Make sure all hydraulic connections are tight and all hydraulic lines and hoses are in good condition before engaging tractor PTO.
___ Check that there are no leaks in the hydraulic system. Before operating, all hydraulic hoses must be routed properly and not be twisted, bent sharply, kinked, pulled tight or frayed.
___ During inspection, check that all nuts and bolts are secure and clevis pins are properly cotter pinned.
___ Be sure special
___ Make sure only original equipment high- strength top link pin, provided with tractor, is used to attach top link to tractor.
___ Use a 1" x 5" grade 5 bolt to mount top link to backhoe.
___ Make sure tractor lower lift arm stabilizers (blocks or chains) are positioned to prevent lift arms and backhoe from swaying.
___ Place all backhoe controls in neutral position before starting tractor engine.
___ Check hydraulic reservoir level.
___ Remove transport lock bar from the boom. Push transport lock bar down fully to prevent damage.
___ Place and keep
___ Set draft sensing control to “heavy” (minimum sensitivity) position. The minimum sensitivity setting indicates to the tractor lift system that a heavy load is being applied to the lift arms and will minimize the potential for the lift arms to raise. Raising lower lift arms would apply
greater loads to the
51861 (Rev. 6/16/2006) | Operation 17 |
|
|