ASSEMBLY
DEALER SET-UP INSTRUCTION
Backhoe assembly is the responsibility of the WOODS dealer. The backhoe should be delivered to the owner completely assembled, lubricated and adjusted for nor- mal operating conditions.
Set up backhoe as received from the factory with the instructions and illustrations.
A CAUTION
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
A lifting bar is provided to maneuver the backhoe while it is on the pallet. While backhoe is on a pallet, do not lift from any other point. When backhoe is removed from the pallet, remove lifting bar and discard.
Remove lag screw from swing frame, rotate boom and dipper and install swing lock pin. Open parts bag and box and lay out parts to make identification easy. Refer to parts lists and exploded view drawing.
The backhoe is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hardware.
Recommended torque values for hardware are given on page 55.
IMPORTANT
■When finished with assembly, the dealer is to complete the check lists on page 34.
ASSEMBLY PROCEDURE
A WARNING
It is recommended that power unit be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in death from being run over or crushed. Keep foldable ROPS systems in “locked up” posi- tion at all times.
Refer to “Mounting Guide” (available from your dealer) for some tractors not originally equipped with 1” diameter pins.
A minimum 20% of tractor and equipment weight must be on tractor front wheels with back- hoe in transport position. Without this weight, trac- tor could tip over, causing personal injury or death. The weight may be attained with a loader, front wheel weights, ballast in tires, or front tractor weights. When attaining the minimum 20% weight on the front wheels, you must not exceed the Roll Over Protection Structure (ROPS) weight certifica- tion. Weigh the tractor and equipment. Do not esti- mate.
Read instructions before starting assembly. You will save yourself assembly time.
Move Seat Support Assembly
Move seat support assembly from the four forward holes on main frame to the four rearward holes for operation. It will be easier to do this before mounting backhoe on tractor.
Bucket & Dipperstick Installation
Align dipperstick cylinder (4) with dipperstick (2) and install pivot pin (6) as shown in Figure 20. Line up hole in pivot pin (6) with hole in pivot bushing and secure with clevis pin (8) and cotter pin (9).
Align bucket (3) with pivot bushings of bucket arm (5) and dipperstick (2) and install pivot pins (7). Line up hole in pivot pin (6) with hole in pivot bushing and secure with bolts (10) and lock nuts (11).
51861 (Rev. 6/16/2006) | Assembly 27 |
|
|