KX-P7100
3.5.High Voltage Board and Power Supply Unit
Before handling, remove the Left Cover ( see Section 3.2 ).
3.5.1.High Voltage Board
(1)Remove the screw ( A ) and 5 screws ( B ).
Caution :
Screw ( A ) is different from screws ( B ). When reinstalling the screw, return it to the original position.
(2)Disconnect the Flat Cable from the High Voltage Board.
(3)Remove the High Voltage Board, be careful that High Voltage Terminal Springs are not dropped from the printer and lost.
(4)Remove the 5 High Voltage Terminal Springs.
Caution :
When reinstalling the High Voltage Terminal Springs, all springs must be returned to the original position. And the hook of Spring ( A ), ( D ), ( E ) are set into the slits as shown in the following figure.
31