Panasonic PT-D5600UL, PT-DW5000U manual Adjusting the position, Tv-System, Position, Aspect

Adjusting the picture

AI

Gray scale control is exercised to suit the images, and optimal images with a clear contrast are projected.

ON : AI compensation is enabled.

OFF : AI compensation is disabled.

TV-SYSTEM

(For S-Video/Video signals)

The setting that corresponds to the TV system is selected here.

AUTO1 : Standard setting

Automatically selects the TV standard that matches the input video signal, out of NTSC, PAL, NTSC4.43, SECAM and PAL60.

AUTO2 : Automatically selects the TV standard that matches the input video signal, out of NTSC, PAL-M, and PAL-N.

•Normally “AUTO1” or “AUTO2” should be chosen for this option.

•If the video signals are not displayed properly due to signal deterioration, choose the TV system that matches the input video signals.

Automatically selected by detecting the horizontal/vertical scan frequencies and color sub- carrier listed in the table below:

Signal	H. Scan	V. Scan	Color
	Frequency	Frequency	Subcarrier
System
	(kHz)	(Hz)	(MHz)
NTSC	15.75	60.00	3.58
NTSC4.43	15.75	60.00	4.43
PAL	15.63	50.00
PAL-M	15.75	60.00	3.58
PAL-N	15.63	50.00
SECAM	15.63	50.00	4.25 or 4.41
PLA60	15.75	60.00	4.43

SYSTEM

(For RGB/YPBPR signals)

This enables the RGB system or YPBPR system to be selected.

For the signals which are supported, refer to page 58.

Adjusting the position

	POSITION
POSITION
ASPECT		4 : 3
ZOOM
CLOCK PHASE		16
KEYSTONE
SELECT	ENTER		RETRN

POSITION

The position where the images are displayed can be moved here.

: The position is moved horizontally. : The position is moved vertically.

ASPECT

AUTO : (For S-Video/Video signals only)

At this setting, when S1 video signals 1 are identified as being input to the S- Video connector or video ID signals are identified as being input to the video connector, the images are displayed after automatically being converted to the 16:9 aspect ratio.

16:9 : At this setting, when standard signals 2 are input, the images are converted to the 16:9 aspect ratio and displayed. When wide-screen signals 3 are input, the images are displayed with their inherent aspect ratio intact.

4:3 : At this setting, when standard signals 2 are input, the images are displayed with their inherent aspect ratio intact. When wide-screen signals 3 are input, they are converted by the PT-D5600U to the 4:3 aspect ratio and displayed. With the PT- DW5000U, the images are reduced in size and displayed without converting their aspect ratio so that they will fit onto a screen with a 4:3 aspect ratio.

S4:3 : Select this setting when using a 16:9 screen.

HV FIT : At this setting, the images are displayed to fill the entire screen.

If the aspect ratios of the input signals and screen differ, the images are converted into the screen’s aspect ratio (4:3 for the PT-D5600U or 15:9 for the PT-DW5000U) and displayed.

1 S1 video signals are 16:9 video signals to which is added the detection signal output from the video deck or other unit which supports the wide-screen format.

2 Here, the standard signal means 4:3 or 5:4 input signals.

3 Here, the wide-screen signals means 16:9, 15:9 or 15:10 input signals.

30