Panasonic PT-D6000U manual Side views, About Your Projector

Page 13

Side views

S-VIDEO IN

Connect an S-VIDEO signals. (Mini DIN 4 pin)

VIDEO IN

Connect a video signals. (BNC)

LAN

Connect a LAN cable for network connection. (10BASE-T/100BASE-TX)

About Your Projector

	RGB 1 IN
	Connect an RGB or YPBPR signals.
	(3, 4 or 5 wire BNC)
	RGB 2 IN
	Connect an RGB or YPBPR signals.	Preparation
	(D-SUB 15 pin female)
	DVI-D IN
	DVI-D IN
	Connect a single link DVI-D signals.

REMOTE 1 IN/OUT Connect a cable from the remote control or another projector.

(M3 jack)

REMOTE 2

Connect a cable from an external control circuit. (D-sub 9 pin female)

SERIAL IN/SERIAL OUT Connect an RS-232C cable from/to a computer.

SDI IN (PT-DZ6710U only) Connect a cable from a computer.

Air intake port

POWER button

Switch the projector on/off. (page 20)

Air intake port

AC IN terminal

Connect the power cord to supply electronic power to the projector. (page 20)

Security lock

Attach the commercial shackle lock, manufactured by Kensington, to protect your projector. Compatible with the Kensington MicroSaver Security System.

Auto Cleaning Filter (ACF) compartment (page 31)

NOTE:

•Switch on the POWER button of the projector body that is located near the terminals before using the control buttons.

•Do not cover the ventilation openings or place anything within 50 cm (20") of them as this may cause damage or injury.

ENGLISH - 13

Image 13

Contents PT-DZ6700U PT-DW6300U PT-D6000U Model number PT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Important Safety NoticeDeclaration of Conformity Important Safety NoticePT-DZ6710U /PT-DZ6700U /PT-DW6300U /PT-D6000U PanasonicEnglish Contents Precautions with regard to safety Insulate the battery using tape or similar before disposal Precautions with regard to safetyDo not look into the lens while the projector is being used Do not disassemble the lamp unitRemove the used batteries from the remote control promptly Do not set up the projector outdoorsDo not put your weight on this projector Always disconnect all cables before moving the projectorDo not reach for the openings beside the optical Replacement of the lamp unit should only be carriedBe sure to always remove the lens during transport Order to get the best picture qualitySecurity OthersRemote control x1 N2QAYB000371 AccessoriesProjector lens cover x1 TKKL5244-1 Power cord secure lock Power cord x1 K2CG3FZ00008Projector body About Your ProjectorTop, front and bottom view About Your Projector Side viewsRemote control About Your Projector Projection method Setting upMounting on the ceiling and projecting from front Mounting on the ceiling and projecting from rearRemoving and attaching the projection lens Setting upRemoving the projection lens From the projector ProjectorConnecting Disconnecting Power cordMaking adjustment and selection Switching on the projectorAdjusting focus, zoom and shift ProjectingAdjustment range after lens position optical shift Direct power off functionProjecting Lens home positionSetting up the image position automatically Remote control operationOperating range Facing to the projectorStopping the projection Switching the input signalClearing the screen Changing the picture aspect ratioResetting to the factory default Using an assigned functionDisplaying the status of the projector Main menu and Sub-menu Menu NavigationRS-232C Menu NavigationSecurity Operating procedure Adjusting with the bar scale itemsNavigating through the menu Displaying the Main menuManaging the indicated problems Monitor Lamp indicatorsLAMP1/LAMP2 indicator Temp indicatorStatus in Projector Setup menu Monitor Lamp indicators Filter indicatorStatus in Projector When to replace the lamp unit ReplacementReplacing the Lamp unit Before replacing the Lamp unitReplacement Replacement procedure Replacing the Auto Cleaning Filter ACFWhen to replace the ACF Before replacing the ACFCounter Reset in Projector Setup Resetting the RemainingTroubleshooting Technical Information List of compatible signalsQuality*2 KHz MHzPT-DZ6710U Display dots of each modelPT-DZ6700U PT-DW6300UTechnical Information SpecificationsSerial Trademark acknowledgements DimensionsUnit mm inch Index Auto SetupIndex Numéro de modèlePT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Avis important concernant la sécuritéDéclaration de conformité Avis important concernant la sécuritéPrécautions de sécurité Pendant un orage, ne pas toucher le projecteur ou le câble Précautions de sécuritéNe pas utiliser lappareil dans un bain ou une douche Ne pas placer plusieurs kits les uns sur les autresPrécautions lors du transport Précautions lors de lutilisation Précautions lors de linstallationAutres Instructions de sécurité SécuritéModifiez fréquemment votre mot de passe Délai de remplacement de lunité de la lampe RemplacementAvant de remplacer le lUnité de la lampe Retirer et remplacer la lampe Remplacement Procédure de remplacement