Panasonic PT-D6000U manual Important Safety Notice, Declaration of Conformity, Panasonic

Page 3

Important Safety Notice

NOTICE:

AThis product has a High Intensity Discharge (HID) lamp that contains mercury. Disposal may be regulated in your community due to environmental considerations. For disposal or recycling information, please contact your local authorities, or the Electronic Industries Alliance: http://www.eiae.org

WARNING:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

FCC CAUTION: To assure continued compliance, follow the attached installation instructions and use only shielded interface cables when connecting to computer and/or peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of North America could void the user's authority to operate this device.

WARNING:

ANot for use in a computer room as defined in the Standard for the Protection of Electronic Computer/Data

Processing Equipment, ANSI/NFPA 75.

AFor permanently connected equipment, a readily accessible disconnect device shall be incorporated in the building installation wiring.

AFor pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.

 

Declaration of Conformity

Model Number:

PT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U

Trade Name:

Panasonic

Responsible party:

Panasonic Corporation of North America

Address:

One Panasonic Way, Secaucus, New Jersey 07094

Telephone number:

(888) 411 - 1996

E-mail:

projectorsupport@us.panasonic.com

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Important Information

ENGLISH - 3

Image 3
Contents PT-DZ6700U PT-DW6300U PT-D6000U Model number PT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Important Safety NoticePanasonic Important Safety NoticeDeclaration of Conformity PT-DZ6710U /PT-DZ6700U /PT-DW6300U /PT-D6000UEnglish Contents Precautions with regard to safety Do not disassemble the lamp unit Precautions with regard to safetyInsulate the battery using tape or similar before disposal Do not look into the lens while the projector is being usedAlways disconnect all cables before moving the projector Do not set up the projector outdoorsRemove the used batteries from the remote control promptly Do not put your weight on this projectorOrder to get the best picture quality Replacement of the lamp unit should only be carriedDo not reach for the openings beside the optical Be sure to always remove the lens during transportSecurity OthersPower cord x1 K2CG3FZ00008 AccessoriesRemote control x1 N2QAYB000371 Projector lens cover x1 TKKL5244-1 Power cord secure lockAbout Your Projector Projector bodyTop, front and bottom view About Your Projector Side viewsRemote control About Your Projector Mounting on the ceiling and projecting from rear Setting upProjection method Mounting on the ceiling and projecting from frontFrom the projector Projector Setting upRemoving and attaching the projection lens Removing the projection lensConnecting Disconnecting Power cordProjecting Switching on the projectorMaking adjustment and selection Adjusting focus, zoom and shiftLens home position Direct power off functionAdjustment range after lens position optical shift ProjectingFacing to the projector Remote control operationSetting up the image position automatically Operating rangeChanging the picture aspect ratio Switching the input signalStopping the projection Clearing the screenUsing an assigned function Resetting to the factory defaultDisplaying the status of the projector Main menu and Sub-menu Menu NavigationRS-232C Menu NavigationSecurity Displaying the Main menu Adjusting with the bar scale itemsOperating procedure Navigating through the menuTemp indicator Monitor Lamp indicatorsManaging the indicated problems LAMP1/LAMP2 indicatorMonitor Lamp indicators Filter indicator Status in Projector Setup menuStatus in Projector Before replacing the Lamp unit ReplacementWhen to replace the lamp unit Replacing the Lamp unitBefore replacing the ACF Replacing the Auto Cleaning Filter ACFReplacement Replacement procedure When to replace the ACFCounter Reset in Projector Setup Resetting the RemainingTroubleshooting KHz MHz List of compatible signalsTechnical Information Quality*2PT-DW6300U Display dots of each modelPT-DZ6710U PT-DZ6700UTechnical Information SpecificationsSerial Dimensions Trademark acknowledgementsUnit mm inch Index Auto SetupIndex Numéro de modèlePT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Avis important concernant la sécuritéDéclaration de conformité Avis important concernant la sécuritéPrécautions de sécurité Ne pas placer plusieurs kits les uns sur les autres Précautions de sécuritéPendant un orage, ne pas toucher le projecteur ou le câble Ne pas utiliser lappareil dans un bain ou une douchePrécautions lors du transport Précautions lors de linstallation Précautions lors de lutilisationAutres Sécurité Instructions de sécuritéModifiez fréquemment votre mot de passe Remplacement Délai de remplacement de lunité de la lampeAvant de remplacer le lUnité de la lampe Retirer et remplacer la lampe Remplacement Procédure de remplacement