Panasonic PT-D6000U manual Precautions with regard to safety, Do not disassemble the lamp unit

Page 7

Precautions with regard to safety

Do not touch the leaked liquid from the batteries. If you touch the leaked liquid, it may hurt your skin. Immediately wash away the liquid with water and seek medical advice.

If you get the leaked liquid in your eye, it may cause blindness or damage. Never rub your eye, and immediately wash away the liquid with water and seek medical advice.

During a thunderstorm, do not touch the projector or the cable.

Electric shocks can result.

Do not use the projector in a bath or shower. Fire or electric shocks can result.

Do not place your skin into the light beam while the projector is being used.

Strong light is emitted from the projector’s lens. If you place directly into this light, it can hurt or damage your skin.

Do not look into the lens while the projector is being used.

Strong light is emitted from the projector’s lens. If you look directly into this light, it can hurt and damage your eyes.

Do not disassemble the lamp unit.

If the lamp section breaks, it may cause injury.

Do not place your hands or other objects close to the air outlet port.

Heated air comes out of the air outlet port. Do not place your hands or face, or objects which cannot withstand heat close to this port [allow at least

50 cm (20") of space], otherwise burns or damage could result.

Replacement of the lamp should be carried out by a qualified technician.

The lamp has high internal pressure. If improperly handled, explosion might result.

The lamp can easily become damaged if struck against hard objects or dropped, and injury or malfunctions may result.

When replacing the lamp, allow it to cool for at least one hour before handling it.

The lamp cover gets very hot, and touching it can cause burns.

Before replacing the lamp, be sure to disconnect the power plug from the wall outlet.

Electric shocks or explosions can result if this is not done.

Do not allow infants or pets to touch the remote control unit.

Keep the remote control unit out of the reach of infants and pets after using it.

After removing the battery from remote control unit, keep it away from the reach of children.

The battery can cause death by suffocation if swallowed.

If the battery is swallowed, seek medical advice immediately.

Insulate the battery using tape or similar before disposal.

If the battery comes into contact with metallic objects or other batteries, it may catch fire or explode.

When installing to a ceiling, be sure to use the accessory wire (install in a different location to the ceiling mount bracket) and the eye bolts as an extra preventative measure to stop the projector from falling down.

If the projector is not secure enough, accidents may result.

Do not place sets directly on top of each other.

If this is not observed, accidents may result.

Do not use the projector while the projection lens cover is still attached to the projection lens.

If this is not observed, fire may occur.

Important Information

CAUTIONS

Do not cover the air inlet port or the air outlet port. Doing so may cause the projector to overheat, which can cause fire or damage to the projector.

Do not place the projector in narrow, badly ventilated places such as closets or bookshelves.

Do not place the projector on cloth or papers, as these materials could be drawn into the air inlet port.

Do not set up the projector in humid or dusty places or in places where the projector may come into contact with oily smoke or steam.

Using the projector under such conditions may result in fire, electric shocks or plastic deterioration. The plastic deterioration may cause the falling down of the projector which is mounted on the ceiling.

ENGLISH - 7

Image 7
Contents PT-DZ6700U PT-DW6300U PT-D6000U Model number PT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Important Safety NoticePanasonic Important Safety NoticeDeclaration of Conformity PT-DZ6710U /PT-DZ6700U /PT-DW6300U /PT-D6000UEnglish Contents Precautions with regard to safety Do not disassemble the lamp unit Precautions with regard to safetyInsulate the battery using tape or similar before disposal Do not look into the lens while the projector is being usedAlways disconnect all cables before moving the projector Do not set up the projector outdoorsRemove the used batteries from the remote control promptly Do not put your weight on this projectorOrder to get the best picture quality Replacement of the lamp unit should only be carriedDo not reach for the openings beside the optical Be sure to always remove the lens during transportSecurity OthersPower cord x1 K2CG3FZ00008 AccessoriesRemote control x1 N2QAYB000371 Projector lens cover x1 TKKL5244-1 Power cord secure lockProjector body About Your ProjectorTop, front and bottom view About Your Projector Side viewsRemote control About Your Projector Mounting on the ceiling and projecting from rear Setting upProjection method Mounting on the ceiling and projecting from frontFrom the projector Projector Setting upRemoving and attaching the projection lens Removing the projection lensConnecting Disconnecting Power cordProjecting Switching on the projectorMaking adjustment and selection Adjusting focus, zoom and shiftLens home position Direct power off functionAdjustment range after lens position optical shift ProjectingFacing to the projector Remote control operationSetting up the image position automatically Operating rangeChanging the picture aspect ratio Switching the input signalStopping the projection Clearing the screenResetting to the factory default Using an assigned functionDisplaying the status of the projector Main menu and Sub-menu Menu NavigationRS-232C Menu NavigationSecurity Displaying the Main menu Adjusting with the bar scale itemsOperating procedure Navigating through the menuTemp indicator Monitor Lamp indicatorsManaging the indicated problems LAMP1/LAMP2 indicatorStatus in Projector Setup menu Monitor Lamp indicators Filter indicatorStatus in Projector Before replacing the Lamp unit ReplacementWhen to replace the lamp unit Replacing the Lamp unitBefore replacing the ACF Replacing the Auto Cleaning Filter ACFReplacement Replacement procedure When to replace the ACFCounter Reset in Projector Setup Resetting the RemainingTroubleshooting KHz MHz List of compatible signalsTechnical Information Quality*2PT-DW6300U Display dots of each modelPT-DZ6710U PT-DZ6700UTechnical Information SpecificationsSerial Trademark acknowledgements DimensionsUnit mm inch Index Auto SetupIndex Numéro de modèlePT-DZ6710U/PT-DZ6700U/PT-DW6300U/PT-D6000U Avis important concernant la sécuritéDéclaration de conformité Avis important concernant la sécuritéPrécautions de sécurité Ne pas placer plusieurs kits les uns sur les autres Précautions de sécuritéPendant un orage, ne pas toucher le projecteur ou le câble Ne pas utiliser lappareil dans un bain ou une douchePrécautions lors du transport Précautions lors de lutilisation Précautions lors de linstallationAutres Instructions de sécurité SécuritéModifiez fréquemment votre mot de passe Délai de remplacement de lunité de la lampe RemplacementAvant de remplacer le lUnité de la lampe Retirer et remplacer la lampe Remplacement Procédure de remplacement